User manual

2 Deutsch
Illustrations on fold-out page!
Illustration
Select the nozzles to match the high pres-
sure cleaner used.
K 2: Use red high pressure nozzles
K 3, K 4, K 5: Use grey high pressure noz-
zles
K 6, K 7: Use yellow high pressure nozzles
(already installed)
Illustration
Î Remove the clips
Î Pull out the unneeded highpressure
nozzles.
Î Select the high pressure nozzles need-
ed to match the high pressure cleaner
used and press them in.
Î Secure with clips.
Illustration
Î Screw the brass adapter onto the high
pressure hose (using a 12 mm open
end wrench).
Illustration
Î Insert the high pressure hose into the
hose guide of the clamping unit as
shown.
Illustration
Î Press the adapter with the high pres-
sure hose into the cleaning sled intake,
secure with clip.
Î Press the high pressure hose into the
fixing of the cleaning sled.
Î Operate the high pressure cleaner as
instructed in the operating instructions.
 Danger
If you use a ladder, make sure it is posi-
tioned securely.
Keep persons out of the cleaning area
while cleaning.
Do not operate the high pressure gun on
the ladder.
Note
Let the shutters down prior to cleaning.
Repark parked cars in the vicinity of the
roof gutter drop pipe.
Î Check the roof gutter prior to cleaning;
remove solids such as shingle remains
or mortar clumps.
Î Always work away from the drop pipe
when cleaning the roof gutter.
Illustration
Î Insert the sieve into the drop pipe of the
roof gutter (if not yet installed).
Illustration
Î Fasten the clamping unit with the hose
guide to the side of the roof gutter.
Note: If necessary, the clamping unit
can also be attached to the front of the
roof gutter.
Illustration
Î Align the hose guide and insert the sled
(at least to the red mark).
Illustration
Î Press the coupling of the high pressure
hose into the bayonet connection of the
high pressure gun.
Î Turn the coupling part by 90° until it
locks into place.
Î Turn on the high-pressure cleaner.
Î Press the lever on the hand spray gun
and begin cleaning.
Î Manually guide the high pressure hose
with driven advance.
Note: In order to increase the rinsing ef-
fect, slowly withdraw the high pressure
hose from time to time against the driv-
en advance; then release again.
Roof gutter cleaning set
Description of the Appliance
1 Adapter to connect to the high pressure
hose to the cleaning sled
2 High pressure hose (pipe cleaning
hose)
3 Red mark
4 Cleaning sled
5 Red high pressure nozzles (2 pieces)
6 Grey high-pressure nozzles (2 pieces)
7 Clamping unit with hose guide
8 Sieve to cover the drop pipe
Preparing the Appliance
Installing the nozzles
Install the adapter to the high pressure
hose and connect the cleaning sled
Operations
9EN