User manual

Problem Possible cause Solution
Food products placed in the
appliance were too warm.
Allow food products to cool
to room temperature before
storing.
The door is not closed cor-
rectly.
Refer to "Closing the door".
The FastFreeze function is
switched on.
Refer to "FastFreeze func-
tion".
The compressor does not
start immediately after press-
ing the FastFreeze, or after
changing the temperature.
This is normal, no error has
occurred.
The compressor starts after a
period of time.
Water flows on the floor. The melting water outlet is
not connected to the evapo-
rative tray above the com-
pressor.
Attach the melting water out-
let to the evaporative tray.
Temperature cannot be set. The FastFreeze or Shopping
function is switched on.
Switch off FastFreeze or
Shopping manually, or wait
until the function resets auto-
matically to set the tempera-
ture. Refer to "FastFreeze or
Shopping function".
DEMO appears on the dis-
play.
The appliance is in demon-
stration mode.
Keep the OK pressed for ap-
proximately 10 seconds until
a long sound is heard and
display shuts off for a short
time.
The temperature in the appli-
ance is too low/too high.
The temperature regulator is
not set correctly.
Set a higher/lower tempera-
ture.
The food products' tempera-
ture is too high.
Let the food products tem-
perature decrease to room
temperature before storage.
The door has been opened
often.
Open the door only if neces-
sary.
The FastFreeze function is
switched on.
Refer to "FastFreeze func-
tion".
There is no cold air circula-
tion in the appliance.
Make sure that there is cold
air circulation in the appli-
ance.
If the advice does not lead to
the desired result, call the
nearest brand-mark service.
28