User manual Freezer ITE139-0
Contents Safety information Control panel First use Daily use Helpful Hints and Tips 2 4 5 5 6 Care and cleaning What to do if… Technical data Installation Environmental concerns 6 7 8 8 9 Subject to change without notice Safety information In the interest of your safety and to ensure the correct use, before installing and first using the appliance, read this user manual carefully, including its hints and warnings.
• It is dangerous to alter the specifications or modify this product in any way. Any damage to the cord may cause a short-circuit, fire and/or electric shock. Warning! Any electrical component (power cord, plug, compressor) must be replaced by a certified service agent or qualified service personnel. 1. Power cord must not be lengthened. 2. Make sure that the power plug is not squashed or damaged by the back of the appliance. A squashed or damaged power plug may overheat and cause a fire. 3.
• This product must be serviced by an authorized Service Centre, and only genuine spare parts must be used. Environment Protection This appliance does not contain gasses which could damage the ozone layer, in either its refrigerant circuit or insulation materials. The appliance shall not be discarded together with the urban refuse and rubbish. The insulation foam contains flammable gases: the appliance shall be disposed according to the applicable regulations to obtain from your local authorities.
Excessive temperature alarm In the event of an abnormal temperature rise inside the freezer (e.g. power cut) Alarm light will start to flash and a buzzer will sound. After the temperature has returned to normal, the Alarm light will continue to flash, although the buzzer has stopped. When the Alarm reset switch is pressed, the warmest temperature reached in the compartment flashes on the Temperature indicator .
Cold accumulators The freezer contains at least one cold accumulator which increases storage time in the event of a power cut or breakdown. these trays with water, then put them in the freezer compartment. Important! Do not use metallic instruments to remove the trays from the freezer. Ice-cube production This appliance is equipped with one or more trays for the production of ice-cubes.
Important! Take care of not to damage the cooling system. Many proprietary kitchen surface cleaners contain chemicals that can attack/damage the plastics used in this appliance. For this reason it is recommended that the outer casing of this appliance is only cleaned with warm water with a little washing-up liquid added. After cleaning, reconnect the equipment to the mains supply. Defrosting of the freezer The freezer compartment of this model, on the other hand, is a "no frost" type.
Problem The temperature in the freezer is too low. The temperature in the freezer is too high. There is too much frost. Possible cause Solution The room temperature is too high. Decrease the room temperature. The Fast freezing function is switched on. Refer to "Fast freezing function". The temperature regulator is not set correctly. Set a higher temperature. The Fast freezing function is switched on. Refer to "Fast freezing function". The temperature regulator is not set correctly.
Climate class Ambient temperature SN +10°C to + 32°C N +16°C to + 32°C ST +16°C to + 38°C T +16°C to + 43°C Electrical connection Before plugging in, ensure that the voltage and frequency shown on the rating plate correspond to your domestic power supply. The appliance must be earthed. The power supply cable plug is provided with a contact for this purpose.
212710171-00-22042009
