User manual

Problem Possible cause Solution
Food products placed in the
appliance were too warm.
Allow food products to cool
to room temperature before
storing.
The door is not closed cor-
rectly.
Refer to "Closing the door".
The Shopping function is
switched on.
Refer to "Shopping function".
The compressor does not
start immediately after press-
ing the Shopping, or after
changing the temperature.
This is normal, no error has
occurred.
The compressor starts after a
period of time.
Water flows on the rear plate
of the refrigerator.
During the automatic defrost-
ing process, frost melts on
the rear plate.
This is correct.
Water flows into the refrigera-
tor.
The water outlet is clogged. Clean the water outlet.
Food products prevent that
water flows into the water
collector.
Make sure that food prod-
ucts do not touch the rear
plate.
Water flows on the floor. The melting water outlet is
not connected to the evapo-
rative tray above the com-
pressor.
Attach the melting water out-
let to the evaporative tray.
Temperature cannot be set. The FastFreeze or Shopping
function is switched on.
Switch off FastFreeze or
Shopping manually, or wait
until the function resets auto-
matically to set the tempera-
ture. Refer to "FastFreeze or
Shopping function".
DEMO appears on the dis-
play.
The appliance is in demon-
stration mode.
Keep the Mode pressed for
approximately 10 seconds
until a long sound is heard
and display shuts off for a
short time.
The temperature in the appli-
ance is too low/too high.
The temperature regulator is
not set correctly.
Set a higher/lower tempera-
ture.
The door is not closed cor-
rectly.
Refer to "Closing the door".
The food products' tempera-
ture is too high.
Let the food products tem-
perature decrease to room
temperature before storage.
29