User manual

1. Check that the baskets have been
loaded correctly and that the spray
arms can rotate freely
2. Turn on the water tap
3. Press the On/Off button
4. Setting and starting the programme
Select the washing programme.
If required, postpone the start time of the washing
programme. Press the delay start button until the number
of hours for the delay start will appear in the display.
Press the OK button and close the door, the washing
programme will start automatically.
If the delay start has been set, the countdown will start
automatically.
Once the delay start has elapsed the programme will start
automatically.
The opening of the door will interrupt the countdown.
Close the door; the countdown will continue from the point
at which it was interrupted.
Once the washing programme has started, a point-shaped
optical signal appears on the floor beneath the
dishwasher’s door. This optical signal will remain
illuminated for all the duration of the washing programme.
If the appliance has been installed higher up with a
furniture door mounted flush, the optical signal will be no
longer visible.
Interrupt or cancel a washing programme in progress
ONLY if it’s absolutely necessary.
Attention! Hot steam may escape when the door is
opened. Open the door carefully.
Interrupt a washing programme in progress:
● Open the dishwasher door; the programme will stop.
The message PLEASE CLOSE DOOR is displayed.
Close the dishwasher door; the programme will continue
from the point at which it was interrupted.
Cancel a washing programme or a delay
start in progress
● Open the dishwasher door.
● Press simultaneously both option and OK buttons.
● The message CONFIRM CANCEL? is displayed.
● Press OK button to confirm.
● The appliance returns to setting mode and the message
CHOOSE PROGRAMME is displayed.
If the delay start is cancelled, also the washing programme
will be cancelled.
If a new washing programme will be set, check that there
is detergent in the detergent dispenser.
5. End of the washing programme
● The dishwasher will automatically stop and an audible
signal informs you of the end of the washing
programme.
When the washing programme has ended, the optical
signal on the floor beneath the dishwasher’s door will turn
off. Open the dishwasher door only when this optical
signal turns off.
If the door is not immediately opened at the end of the
programme, air will circulate inside the dishwasher to
prevent residual steam recondensing on the dishes as
water droplets.
This device operates intermittently for about 20
minutes, as long as the dishwasher is switched on.
If the On/Off button is pressed or the door is opened
during these 20 minutes, the device will be automatically
cancelled.
● Open the door.
● The messages PROGRAMME END alternated with
PLEASE SWITCH OFF are displayed.
If filling with rinse aid and/or salt is necessary the message
PLEASE SWITCH OFF will not appear. Instead, the
refilling salt and rinse aid messages alternated with
PROGRAMME END.
It is possible, however, to switch off the appliance
● Press the On/Off button.
● Leave the door ajar and wait a few minutes before
removing the dishes; in this way they will be cooler and
the drying will be improved.
6. Unloading the dishwasher
● Hot dishes are sensitive to knocks. The dishes should
therefore be allowed to cool down before removing from
the appliance.
● Empty the lower basket first and then the upper one; this
will avoid water dripping from the upper basket onto the
dishes in the lower one.
● Water may appear on the sides and the door of the
dishwasher as the stainless steel will eventually become
cooler than the dishes.
When the washing programme has finished, it is
recommended that the dishwasher is unplugged and the
water tap turned off.
Starting a washing programme
16