User manual

Use of detergent
Only use detergents specifically designed for use in
dishwashers.
Using no more then the correct amount of detergent
contributes to reducing pollution.
Please observe the manufacturer’s dosing and storage
recommendations as stated on the detergent packaging.
Fill with detergent
1. Open the lid.
2. Fill the detergent dispenser (1) with detergent.
The marking indicates the dosing levels:
20 = approximately 20 g of detergent
30 = approximately 30 g of detergent
3. All programmes with prewash need an additional detergent
dose (5/10 g) that must be placed in the prewash detergent
chamber (2). This detergent will take effect during the
prewash phase.
When using detergent tablets; place the tablet in
compartment (1)
4. Close the lid and press
until it locks in place.
Detergent tablets
Detergent tablets from different manufactures dissolve at
different rates. For this reason, some detergent tablets do not
attain their full cleaning power during short washing
programmes. Therefore, please use long washing programmes
when using detergent tablets, to ensure the complete removal
of detergent residuals.
3 in 1 function
This appliance is equipped with the 3 in 1 function, that allows
the use of the ‘3 in 1’ combi detergent tablets.
These products are detergents with a combined cleaning,
rinsing and salt functions. They can also contain other different
agents depending on which kind of tablets you choose (‘3 in 1’,
‘4 in 1’, ‘5 in 1’ etc...)
Check whether these detergents are suitable for your water
hardness. See the manufacturers instructions.
Once this function is selected it will remain active also for the
following washing programmes.
With the selection of this function the inflow of rinse aid and
salt from each respective supply container is automatically
deactivated and also the displayed messages for salt and rinse
aid are deactivated.
Select the 3 in 1 function before the start of a washing
programme.
With the use of the 3 in 1 function, the cycle durations may
change. In this case, in the display, the indication of the time is
automatically updated.
Once the programme is running, the 3 in 1 function can NO
longer be changed. If you want to exclude the 3 in 1 function
you have to cancel the programme setting and then deactivate
the 3 in 1 function.
In this case you have to set a washing programme (and
desired options) again.
If the drying results are not satisfactory we
recommend that you:
1. Fill up the rinse aid dispenser with rinse aid.
2. Activate the rinse aid dispenser.
3. Set the rinse aid dosage to position 2.
● The activation/deactivation of the rinse aid dispenser can
only be possible with the 3 in 1 function active.
If you decide to turn back to the use of the
standard detergent system we advise that you:
1. Deactivate the 3 in 1 function.
2. Fill up the dispensers for salt and rinse aid again.
3. Adjust the water hardness setting to the highest setting and
perform 1 normal washing programme without loading any
dishes.
4. Adjust the water hardness setting according to the hardness
of the water in your area.
5. Adjust the rinse aid dosage.
14
1
2