User manual
21
Any electrical work required to install this
appliance should be carried out by a qualified
electrician or competent person.
Any plumbing work required to install this
appliance should be carried out by a qualified
plumber or competent person.
Remove all packaging before positioning the machine.
If possible, position the machine next to a water tap and a
drain.
Water supply connections
This dishwasher may be fed with either hot (max. 60°) or
cold water.
Nevertheless we advise you a cold water supply.
A hot water supply is not always efficient with very soiled
crockery as it shortens the washing programmes a lot.
The water pressure must be within the limits given in the
technical specifications.
Your local Water Authority will advise you on the average
mains pressure in your area.
The dishwasher features fill and drain hoses which can be
turned either to the left or the right to suit the installation.
The locknut must be correctly fitted to avoid water leaks.
Avoid bends or kinks in the hose which could prevent or
slow down the water supply.
If the machine is connected to new pipes or pipes which
have not been used for a long time, you should run the
water for a few minutes before connecting the inlet hose.
This will prevent deposits of sand or rust clogging the inlet
hose filter.
For making the connection itself, the coupling nut fitted to
the machine’s supply hose is designed to screw onto
either a 3/4 inch gas thread spout, or to a purpose made
quick-coupling tap such as the Press-block.
The water supply hose is fitted with a safety device, which
prevents water from entering the machine should the inner
hose split, due to wear.
The problem is signalled by a red indicator which appears
in the window (B - ➀ ➁).
If this happens, close the water tap and have the hose
replaced.
The retaining ring (A - ➀ ➁) must be properly fitted so as
to avoid water leaks.
Note:
Only for water supply hoses with Lock-fast safety device
to prevent inadvertent loosening.
To detach the hose press yellow lever (C - ➁) and turn the
retaining ring anticlockwise ➁.
B
A
B
A
C
CA13
1
2
Installation instructions