EN User Manual Dishwasher IGV6504
CONTENTS Safety information Safety Instructions Product description Control panel Programmes Settings Options 2 3 5 5 6 7 8 Before first use Daily use Hints and tips Care and cleaning Troubleshooting Technical information 9 10 11 12 14 15 Subject to change without notice. SAFETY INFORMATION Before the installation and use of the appliance, carefully read the supplied instructions. The manufacturer is not responsible if an incorrect installation and use causes injuries and damages.
• • Do not use water spray and steam to clean the appliance. The appliance is to be connected to the water mains using the new supplied hose-sets. Old hose sets must not be reused.
Water connection • Make sure not to cause damage to the water hoses. • Before you connect the appliance to new pipes or pipes not used for a long time, let the water flow until it is clean. • The first time you use the appliance, make sure that there is no leakage. • The water inlet hose has a safety valve and a sheath with an inner mains cable. • Do not drink and play with the water in the appliance. • Do not remove the dishes from the appliance until the programme is completed.
PRODUCT DESCRIPTION 1 2 11 10 1 2 3 4 5 6 7 9 8 7 Upper spray arm Lower spray arm Filters Rating plate Salt container Air vent Rinse aid dispenser 4 6 5 8 9 10 11 Detergent dispenser Cutlery basket Lower basket Upper basket 3 CONTROL PANEL 1 2 5 1 2 3 4 On/off button Programme indicators Indicators Programme button 4 3 5 Half Load button
Indicators Indicator Description End indicator. Salt indicator. It is always off while the programme operates. Rinse aid indicator. It is always off while the programme operates. PROGRAMMES Programme 2) 3) 4) Degree of soil Type of load Programme phases Normal soil Crockery and cutlery • • • • Heavy soil Crockery, cutlery, pots and pans Consumption values 1) Duration (min) Energy (kWh) Water (l) Prewash Wash 50 °C Rinses Dry 195 1.
SETTINGS Programme selection mode and user mode When the appliance is in programme selection mode it is possible to set a programme and to enter the user mode. In user mode, the following settings can be changed: • The level of the water softener according to the water hardness. • The activation or the deactivation of the acoustic signal for end of programme. These settings will be saved until you change them again.
How to set the water softener level default this acoustic signal is deactivated but it is possible to activate it. The appliance must be in programme selection mode. How to activate the acoustic signal for the end of programme 1. To enter the user mode, press and hold the programme button until the indicator starts to flash and the indicator comes on with fixed light. 2. Wait until the indicator goes off and the indicator starts to flash. The indicator continues to flash.
If the option is non compatible with the selected programme, the Half Load indicator does not come on. BEFORE FIRST USE The salt container CAUTION! Only use salt specifically designed for dishwashers. 4. Remove the salt around the opening of the salt container. 5. Turn the cap of the salt container clockwise to close the salt container. Water and salt can come out from the salt container when you fill it. Risk of corrosion. To prevent it, after you fill the salt container, start a programme.
CAUTION! Only use rinse aid specifically designed for dishwashers. 1. Turn the cup (C) counterclockwise to open the dispenser. 2. Pour the rinse aid in the dispenser (A) until the liquid reaches the fill level 'max'. 3. Remove the spilled rinse aid with an absorbent cloth to prevent too much foam. 4. Put the cap in position and turn it clockwise to close the dispenser. You can turn the selector of the released quantity (B) between position 1 (lowest quantity) and position 4 or 6 (highest quantity).
Cancelling the programme Press and hold the programme button until the appliance is in programme selection mode. Make sure that there is detergent in the detergent dispenser before you start a new programme. 1. Press the on/off button to deactivate the appliance. 2. Close the water tap. If you do not deactivate the appliance within 5 minutes all indicators goes off. This helps to decrease energy consumption. End of the programme When the programme is completed the indicator is on.
1. Set the highest level of the water softener. 2. Make sure that the salt and rinse aid containers are full. 3. Start the shortest programme with a rinsing phase. Do not add detergent and do not load the baskets. 4. When the programme is completed, adjust the water softener according to the water hardness in your area. 5. Adjust the released quantity of rinse aid. Loading the baskets • Only use the appliance to wash items that are dishwasher-safe.
1. Turn the filter (B) counterclockwise and remove it. 7. Reassemble the filters (B) and (C). 8. Put back the filter (B) in the flat filter (A). Turn it clockwise until it locks. 2. Remove the filter (C) out of filter (B). 3. Remove the flat filter (A). 4. Wash the filters. CAUTION! An incorrect position of the filters can cause bad washing results and damage to the appliance. Cleaning the spray arms Do not remove the spray arms.
• If you regularly use short duration programmes, these can leave deposits of grease and limescale inside the appliance. To prevent this, we recommend to run long duration programmes at least 2 times per month. TROUBLESHOOTING If the appliance does not start or it stops during operation, before you contact an Authorised Service Centre, check if you can solve the problem by yourself with the help of the information in the table.
The washing and drying results are not satisfactory Problem Possible solution There are whitish streaks or bluish layers on glasses and dishes. • The release quantity of rinse aid is too much. Adjust the rinse aid selector to a lower position. • The quantity of detergent is too much. There are stains and dry water drops on glasses and dishes. • The released quantity of rinse aid is not sufficient. Adjust the rinse aid selector to a higher position. • The quality of the rinse aid can be the cause.
Küppersbusch Hausgeräte GmbH Postfach 10 01 32, D-45801 Gelsenkirchen, Küppersbuschstr. 16, D-45883 Gelsenkirchen Telefon: (02 09) 4 01-0, Telefax: (02 09) 4 01-3 03 www.kueppersbusch.
