User manual

A
B
C
A
B
C
1. To unlock the filter system, turn the
handle on the microfilter (B) approxi-
mately 1/4 counterclockwise.
2. Remove the filter system.
3. Hold the coarse filter (A) by the handle
with the hole.
4. Remove the coarse filter (A) from the
microfilter (B).
5. Remove the flat filter (C) from the bot-
tom of the appliance.
D
6. Clean the filters below running water.
7. Put the flat filter (C) to its initial position.
Make sure that it assembles correctly
under the two guides (D).
8. Put the coarse filter (A) in the microfilter
(B) and push the filters together.
9. Put the filter system in position.
10. To lock the filter system, turn the han-
dle on the microfilter (B) clockwise until
it locks in position.
To clean the spray arms
Do not remove the spray arms.
If the holes in the spray arms become clog-
ged, remove remaining parts of soil with a
thin pointed object.
To clean the external surfaces
Clean the external surfaces of the appliance
and control panel with a moist soft cloth.
Only use neutral detergents.
Do not use abrasive products, abrasive
cleaning pads or solvents (acetone).
What to do if…
The appliance does not start or stops dur-
ing operation.
First try to find a solution to the problem (re-
fer to the chart). If not, contact the service
centre.
Malfunction Fault code Possible cause Possible solution
The appliance
does not fill with
water.
• The light of the pro-
gramme in progress
flashes.
• The end-of-programme
indicator light flashes 1
time.
The water tap is
blocked or is furred with
limescale.
Clean the water tap.
The water pressure is
too low.
Contact your local wa-
ter authority.
The water tap is closed. Open the water tap.
13