User manual
43
In this fully integrated appliance the controls are located on the
top of the door. When selecting a programme, the door needs
to be open.
1. Check that the baskets have been
loaded correctly and that the spray
arms can rotate freely
2. Turn on the water tap
3. Press the On/Off push button
The On/Off indicator light illuminates.
4. Setting and starting the programme
Press the push button of the programme you wish to
select. (See "Washing programmes").
The corresponding indicator light starts flashing.
Close the dishwasher door, the programme starts
automatically.
An audible signal informs you that the programme has
started.
If the door has not been closed and the wash
programme has not started, you can still change the
selection made by simply pressing the push button of
another washing programme.
5. To interrupt or cancel a washing
programme
Interrupt or cancel a washing programme in progress
ONLY if it’s absolutely necessary
To interrupt a washing programme
Attention! Hot steam may escape when the door is
opened. There is risk of scalding. Open the door
carefully.
● Open the dishwasher door; the programme will stop.
Close the door; the programme will start from the
point in which it was interrupted.
● pressing the On/Off (in this case all the indicator
lights turn off). Press the On/Off push button again;
the programme will start from the point in which it was
interrupted.
To cancel a washing programme in progress
Open the door and press the push button corresponding to
the programme in progress until the corresponding
indicator light turns off. The dishwasher has now returned
to setting mode.
6. End of the washing programme
The dishwasher will automatically stop and an audible
signal informs you that the programme has ended.
Hot steam may escape from the appliance when opening
the door immediately after the end of the programme,
therefore, open the door carefully.
The On/Off indicator light is flashing while the indicator
light of the ended programme is off.
Switch off the dishwasher by pressing the On/Off push
button.
Unloading the dishwasher
Hot dishes are sensitive to knocks. The dishes should
therefore be allowed to cool down before removing from
the appliance.
Leave the dishes in the dishwasher for approx. 15
minutes, with the door ajar, after the end of programme
so that they dry better and will be cooler.
Empty the lower basket first and then the upper one; this
will avoid water dripping from the upper basket onto the
dishes in the lower one.
When the washing programme has finished, it is
recommended that the dishwasher is unplugged and the
water tap turned off.
Starting a washing programme