LIBRETTO ISTRUZIONI E GB Manual de instrucciones Instruction book IGV 458.
Contents Safety instructions 35 Disposal 35 Economical and ecological dishwashing 35 Description of the appliance 36 The control panel 36 Prior to using for the first time Setting the water softener Filling with salt Rinse aid 37 37 38 38 In daily use Loading cutlery and dishes The lower basket The cutlery basket The upper basket Adjusting the height of the upper basket Use of detergent 39 39 40 40 40 40 41 Washing programmes 42 Starting a washing programme 43 Maintenance and cleaning Clea
Safety instructions It is most important that this instruction book should be retained with the appliance for future reference. Should the appliance be sold or transferred to another owner, or should you move house and leave the appliance, always ensure that the book is left with the appliance in order that the new owner can get to know the functioning of the appliance and the relevant safety information. ● This information has been provided in the interest of your safety.
Description of the appliance 1. Upper basket stop 2. Upper spray arm 3. Salt container 4. Detergent dispenser 5. Control panel 6. Rinse aid dispenser 7. Filters 8. Lower spray arm 9. Upper basket 1 9 2 8 3 7 4 6 5 IN97 The control panel To deactivate these audible signals, press simultaneously "2" and "3" programme push buttons, after about 3 seconds an audible signal informs you that the audible signals have been deactivated.
Prior to using for the first time Before using your dishwasher for the first time: To set a different level, proceed as follows: 1. Ensure that the electrical and water connections comply with the installation instructions 1. Press simultaneously programme push buttons "2" and "4" for about 5 seconds. The programme push button indicator light, corresponding to current level flashes. 2. Remove all packaging from inside the appliance 3. Set the water softener 4.
Filling with salt Rinse aid Rinse aid is automatically added during the last rinse, ensuring thorough rinsing, and spot and streak free drying. The dispenser, which is positioned inside the door, holds about 110 ml of rinse aid, which is sufficient for 16 - 40 dishwashing programmes, depending upon the dosage setting. Special salt can be added in one of two ways: ● If you are using dishwasher detergent that already contains salt, the detergent including the salt is placed in the detergent compartment.
Clean up any rinse aid spilt during filling with an absorbent cloth to avoid excess foaming during the next wash. Adjusting the dose According to the finish and drying results obtained, adjust the dose of rinse aid by means of the 6 position selector (C) (position 1 minimum dosage, position 6 maximum dosage). Only use branded rinse aid for dishwashers. Never fill the rinse aid dispenser with any other substances (e.g. dishwasher cleaning agent, liquid detergent). This would damage the appliance.
Open the door and slide out the baskets to load the dishes. The upper basket The upper basket is designed for plates (dessert plates, saucers, dinner plates of up to 24 cm in diameter), salad bowls, cups and glasses. Arrange items on and underneath the cup racks so that water can reach all surfaces. The cup rack on the left folds upwards to increase your loading flexibility. Glasses with long stems can be placed upside down in the cup racks. Light items (plastic bowls etc.
Use of detergent Detergent tablets Only use detergents specifically designed for use in dishwashers. Detergent tablets of different brands dissolve at different speeds. For this reason some detergent tablets cannot develop their full cleaning power during short programmes. Therefore please use normal programmes with prewash when using detergent tablets. Using no more then the correct amount of detergent contributes to reducing pollution.
Washing programmes Programme Rinse and Hold Intensive 70° Normal 65° (1) Eco 50° (2) Quick 50° Degree of soil and type of load Programme push button Cycle description (3) Consumption values Programme duration (in minutes) Energy consumption (in kWh) Water consumption (in litres) Any. Partial load (to avoid food scraps from sticking together). 1 cold rinse (to avoid food scraps from sticking together) 12 0,02 7 Heavy soil.
Starting a washing programme In this fully integrated appliance the controls are located on the top of the door. When selecting a programme, the door needs to be open. 6. End of the washing programme The dishwasher will automatically stop and an audible signal informs you that the programme has ended. Hot steam may escape from the appliance when opening the door immediately after the end of the programme, therefore, open the door carefully. 1.
Maintenance and cleaning Clean the external surfaces of the machine and control panel with a damp soft cloth. If necessary use only neutral detergents. Never use abrasive products, scouring pads or solvent (acetone, trichloroethylene etc....). To ensure a correct working of the dishwasher, NEVER try to remove the upper spray arm. Ensure that the seals around the door, the detergent and rinse aid dispensers are cleaned regularly with a damp cloth.
What to do, when... Certain problems are due to the lack of simple maintenance or oversights, which can be solved with the help of the instructions given here, without calling out an engineer. ...a flashing fault code appears The dishwasher does not start or stops during operation. An intermittent audible signal informs you that an alarm is activated. All push buttons are inoperative except for the On/Off push button.
...the wash results are not satisfactory The dishes are not clean ● ● ● ● ● ● ● ● The wrong washing programme has been selected. The dishes were arranged in such a way as to stop water reaching all parts of the surface. The baskets must not be overloaded. The spray arms do not rotate freely due to wrong arrangement of the load. The filters in the base of the washing compartment are dirty or incorrectly positioned. Too little or no detergent has been used.
Installation instructions Any electrical and/or plumbing work required to install this appliance should be carried out by a qualified electrician and/or plumber or competent person. Water supply connections This dishwasher may be fed with either hot (max. 50°) or cold water. Nevertheless we advise you a cold water supply. A hot water supply is not always efficient with very soiled crockery as it shortens the washing programmes a lot. Remove all packaging before positioning the machine.
Water outlet hose connection Electrical connection The end of the drain hose can be connected in the following ways: Information concerning the electrical connection is given on the rating plate on the edge of the dishwasher’s door on the right. 1. To the sink outlet spigot, securing it to the underside of the work surface. This will prevent waste water from the sink running into the machine. Before plugging the appliance into the wall socket, make sure that: 1.
Hints for test centres Testing in accordance with EN 60704 must be carried out with appliance fully loaded and using the test programme (see "Washing programmes" chart). Test in accordance with EN 50242 must be carried out when the salt dispenser and rinse aid container have been filled with salt and rinse aid respectively and using the test programme (see "Washing programmes" chart).
Küppersbusch Vertriebsgesellschaft mbH Postfach 10 01 32, D-45801 Gelsenkirche, Küppersbuschstraße 16, D-45883 Gelsenkirchen Telefon (02 09) 4 01-0, Telefax (02 09) 4 01-3 03 152969 37/0 Con riserva di modifiche - Salvo modificaciones Subject to change without notice 0 02/03
