User manual
54
1. Check that the baskets have been
loaded correctly and that the spray
arms can rotate freely
2. Turn on the water tap
3. Close the dishwasher door
4. Press the On/Off push button
The On/Off indicator light illuminates.
5. Setting and starting the programme
Press the push button of the programme you wish to
select. (See "Washing programmes" chart for the
number of the programme).
The corresponding indicator light illuminates and in the
digital display will flash the running time of the programme.
The indicator lights of the phases foreseen for the
programme will illuminate.
The start of the programme will occur automatically about
3 seconds after the last pressure of a push button.
Once the programme has started, in the digital display
the running time of the programme is no longer flashing
and the indicator lights of the phases will turn off except
for the phase underway.
6. To interrupt or cancel a washing
programme
Interrup or cancel a washing programme in progress
ONLY if it’s absolutely necessary.
Attention! Hot steam may escape when the door is
opened. Open the door carefully.
To interrupt a washing programme
● Open the dishwasher door; the programme will stop.
Close the door; the programme will start from the
point in which it was interrupted.
● pressing the On/Off (in this case all the indicator
lights turn off). Press the On/Off push button again;
the programme will start from the point in which it was
interrupted.
To cancel a washing programme in progress
● Press simultaneously the function push buttons 2 and
3 for about 2 seconds, the indicator light of the
running programme will flash for about 2 seconds.
After about 2 seconds all the indicator lights will turn off
(except for the On/Off indicator light). At this point the
washing programme has been cancelled.
7. End of the washing programme
The dishwasher will automatically stop.
The end of programme indicator light is illuminated.
In the digital display appears 0 (remaining programme
time), only in this case switch off the dishwasher.
If the door is not immediately opened at the end of the
programme, air will circulate inside the dishwasher to
prevent residual steam recondensing on the dishes as
water droplets.
This device operates intermittently for about 20
minutes, as long as the dishwasher is switched on.
If the On/Off push button is pressed or the door is
opened during these 20 minutes, the device will be
automatically cancelled.
Switch off the dishwasher by pressing the On/Off push
button.
Open the door and wait a few minutes before removing
the dishes; in this way they will be cooler and the drying
will be improved.
Unloading the dishwasher
Hot dishes are sensitive to knocks. The dishes should
therefore be allowed to cool down before removing from
the appliance.
Empty the lower basket first and then the upper one; this
will avoid water dripping from the upper basket onto the
dishes in the lower one.
Water may appear on the sides and door of the
dishwasher as the stainless steel will eventually become
cooler than the dishes.
When the washing programme has finished, it is
recommended that the dishwasher is unplugged and the
water tap turned off.
"3 in 1" function
This function can be selected together with all
programmes (except the "Rinse and Hold" programme).
Place the 3 in 1 combi detergent tablet in the detergent
dispenser.
Press the "On/Off" push button, the On/Off indicator light
illuminates.
Press the 3 in 1 function push button, the correspondent
indicator light illuminates. Remember that if this function is
selected, it will remain active also for the following
programmes, until it will be deactivated by pressing the 3
in 1 function push button (indicator light off).
Select the required washing programme, after about 3
seconds the programme will start automatically.
Once the programme is running, the 3 in 1 function can
NO longer be changed. If you want to exclude the 3 in 1
function you have to cancel the programme setting (see
"To cancel a washing programme in progress") and then
deactivate the 3 in 1 function by pressing the 3 in 1 push
button.
In this case you have to set a washing programme again.
With the use of 3 in 1 combi detergent tablets, the cycle
durations given in the "Washing programmes" chart may
change.
Starting a washing programme