EN User Manual Dishwasher IG6504
CONTENTS Safety information Safety Instructions Product description Control panel Programmes Settings 2 3 5 6 7 7 Before first use Daily use Hints and tips Care and cleaning Troubleshooting Technical information 9 10 11 12 14 15 Subject to change without notice. SAFETY INFORMATION Before the installation and use of the appliance, carefully read the supplied instructions. The manufacturer is not responsible if an incorrect installation and use causes injuries and damages.
• The appliance is to be connected to the water mains using the new supplied hose-sets. Old hose sets must not be reused. Children and vulnerable people safety • • • • • This appliance can be used by children aged from 8 years and above and persons with reduced physical, sensory or mental capabilities or lack of experience and knowledge if they have been given supervision or instruction concerning use of the appliance in a safe way and understand the hazards involved.
• The first time you use the appliance, make sure that there is no leakage. • The water inlet hose has a safety valve and a sheath with an inner mains cable. completed. There can be detergent on the dishes. • The appliance can release hot steam if you open the door while a programme operates. • Do not put flammable products or items that are wet with flammable products in, near or on the appliance. Service WARNING! Dangerous voltage.
PRODUCT DESCRIPTION 1 2 11 10 1 2 3 4 5 6 7 9 Upper spray arm Lower spray arm Filters Rating plate Salt container Air vent Rinse aid dispenser 8 7 4 6 5 8 9 10 11 Detergent dispenser Cutlery basket Lower basket Upper basket 3
CONTROL PANEL 1 2 5 1 On/off indicator 2 Programme marker 3 Indicators 3 4 4 Start button 5 Programme knob Indicators Indicator Description Washing phase. It comes on when the washing phase operates. Drying phase. It comes on when the drying phase operates. End indicator. Salt indicator. It is always off while the programme operates.
PROGRAMMES Programme 2) 3) 4) Degree of soil Type of load Programme phases Normal soil Crockery and cutlery • • • • Heavy soil Crockery, cutlery, pots and pans Consumption values 1) Duration (min) Energy (kWh) Water (l) Prewash Wash 50 °C Rinses Dry 195 1.02 11 • • • • Prewash Wash 70 °C Rinses Dry 130 150 1.3 - 1.4 13 - 15 Normal soil Crockery and cutlery • • • • Prewash Wash 65 °C Rinses Dry 100 110 1.2 - 1.
detrimental effect on the washing results and on the appliance. How to set the programme selection mode The higher the content of these minerals, the harder your water is. Water hardness is measured in equivalent scales. The appliance is in programme selection mode when the on/off indicator comes on and start indicator starts to flash. When you activate the appliance, usually it is in programme selection mode.
• The intermittent flashing of refers to the current set level, e.g. 5 flashes + pause + 5 flashes = level 5. 3. Press the Start button again and again to change the setting. Each time you press the Start button the level number increases. After level 10 you will start again from level 1. 4. Turn knob to on/off position to confirm the setting. BEFORE FIRST USE 1. Make sure that the current level of the water softener agrees with the hardness of the water supply.
How to fill the rinse aid dispenser C 20 MAx A B Fill the rinse aid dispenser when the indicator (D) becomes clear. + 1 4 30 D 2 1. Turn the cup (C) counterclockwise to open the dispenser. 2. Pour the rinse aid in the dispenser (A) until the liquid reaches the fill level 'max'. 3. Remove the spilled rinse aid with an absorbent cloth to prevent too much foam. 4. Put the cap in position and turn it clockwise to close the dispenser.
• Start indicator starts to flash. 4. Press Start. • The programme starts and the indicator of the washing phase is on. • On/off indicator and start indicator are on. Opening the door while the appliance operates If you open the door while a programme is running, the appliance stops. When you close the door, the appliance continues from the point of interruption. Cancelling the programme Make sure that there is detergent in the detergent dispenser before you start a new programme.
• Do not use more than the correct quantity of detergent. Refer to the instructions on the detergent packaging. What to do if you want to stop using multi-tablets Before you start to use separately detergent, salt and rinse aid do the following procedure. 1. Set the highest level of the water softener. 2. Make sure that the salt and rinse aid containers are full. 3. Start the shortest programme with a rinsing phase. Do not add detergent and do not load the baskets. 4.
C B A 1. Turn the filter (B) counterclockwise and remove it. 2. Remove the filter (C) out of filter (B). 3. Remove the flat filter (A). 4. Wash the filters. 5. Make sure that there are no residues of food or soil in or around the edge of the sump. 6. Put back in place the flat filter (A). Make sure that it is correctly positioned under the 2 guides. 7. Reassemble the filters (B) and (C). 8. Put back the filter (B) in the flat filter (A). Turn it clockwise until it locks.
• Only use neutral detergents. • Do not use abrasive products, abrasive cleaning pads or solvents. CAUTION! An incorrect position of the filters can cause bad washing results and damage to the appliance. Internal cleaning Cleaning the spray arms • Carefully clean the appliance, including the rubber gasket of the door, with a soft moist cloth. • If you regularly use short duration programmes, these can leave deposits of grease and limescale inside the appliance.
Problem and alarm code Possible solution The appliance does not drain the water. • The end indicator flashes 2 times intermittently. • The Start indicator flashes continuously. • Make sure that the sink spigot is not clogged. • Make sure that the drain hose has no kinks or bends. The anti-flood device is on. • The end indicator flashes 3 times intermittently. • The Start indicator flashes continuously. • Close the water tap and contact an Authorised Service Centre.
Power consumption Left-on mode (W) 0.50 Power consumption Off-mode (W) 0.50 1) Refer to the rating plate for other values. 2) f the hot water comes from alternative source of energy, (e.g. solar panels, aeolian energy), use the hot water supply to decrease energy consumption. ENVIRONMENTAL CONCERNS Recycle the materials with the symbol . Put the packaging in applicable containers to recycle it.
Küppersbusch Hausgeräte GmbH Postfach 10 01 32, D-45801 Gelsenkirchen, Küppersbuschstr. 16, D-45883 Gelsenkirchen Telefon: (02 09) 4 01-0, Telefax: (02 09) 4 01-3 03 www.kueppersbusch.
