User manual
6. Set the temperature.
7. Press to confirm.
Steam cooking
The water drawer cover is in the control
panel.
WARNING! Do not put water
directly into the steam
generator.
Use only cold tap water. Do not
use filtered (demineralised) or
distilled water. Do not use other
liquids. Do not put flammable or
alcoholic liquids into the water
drawer.
1.
Press the cover of the water drawer to
open it.
2.
Fill the water drawer with 800 ml of
water.
The water supply is sufficient for
approximately 50 minutes.
3.
Push the water drawer to its initial
position.
4. Turn on the appliance.
5. Set a steam heating function and the
temperature.
6. If necessary, set the function: Duration
or: End Time .
The steam appears after approximately
2 minutes. When the appliance reaches
the set temperature, the signal sounds.
When the steam generator is
empty, the signal sounds.
The signal sounds at the end of the cooking
time.
7. Turn off the appliance.
CAUTION! The appliance is
hot. There is a risk of burns.
Be careful when you empty
the water tank.
8. After Steam Cooking steam can
condensate on the bottom of the cavity.
Always dry the bottom of the cavity
when the appliance is cool.
Let the appliance dry fully with the door
open.
When the appliance cools down, soak up
all remaining water from the steam
generator with the sponge. If necessary,
clean the steam generator with some
vinegar.
Heat-up indicator
When you activate a heating function, the
bar on the display comes on. The bar
shows that the temperature increases.
When temperature is reached the buzzer
sounds 3 times and the bar flashes and
then disappears.
Fast Heat Up Indicator
This function decreases the heat-up time.
Do not put food in the oven
when the Fast heat up function
operates.
To activate the function, hold for 3
seconds. The heat-up indicator alternates.
Residual heat
When you deactivate the appliance, the
display shows the residual heat. You can
use the heat to keep the food warm.
13