User manual
Table Of Contents
- CONTENTS
- SAFETY INFORMATION
- SAFETY INSTRUCTIONS
- PRODUCT DESCRIPTION
- CONTROL PANEL
- BEFORE FIRST USE
- DAILY USE
- CLOCK FUNCTIONS
- AUTOMATIC PROGRAMMES
- USING THE ACCESSORIES
- ADDITIONAL FUNCTIONS
- HINTS AND TIPS
- Advice for special heating functions of the oven
- Cooking with steam
- Steam water table
- Full Steam / ECO Steam
- Turbo Grilling and Full Steam in succession
- Half Steam + Heat
- Quarter Steam + Heat
- Baking
- Tips on baking
- Baking on one level:
- Bakes and gratins
- Moist Fan Baking
- Multilevel Baking
- Pizza Setting
- Roasting
- Roasting tables
- Grilling
- Frozen Foods
- Slow Cooking
- Defrost
- Preserving
- Drying
- Bread Baking
- Core temperature sensor table
- CARE AND CLEANING
- TROUBLESHOOTING
- TECHNICAL DATA
- ENERGY EFFICIENCY

Removing and installing the
door
You can remove the door and the internal
glass panels to clean it. The number of
glass panels is different for different models.
WARNING! Be careful when
you remove the door from the
appliance. The door is heavy.
1. Open the door fully.
2. Fully press the clamping levers (A) on
the two door hinges.
A
A
3.
Close the oven door to the first opening
position (approximately 70° angle).
4.
Hold the door with one hand on each
side and pull it away from the appliance
at an upwards angle.
5. Put the door with the outer side down
on a soft cloth on a stable surface. This
is to prevent scratches.
6. Hold the door trim (B) on the top edge
of the door at the two sides and push
inwards to release the clip seal.
1
2
B
7. Pull the door trim to the front to remove
it.
8. Hold the door glass panels on their top
edge one by one and pull them up out
of the guide.
9.
Clean the glass panel with water and
soap. Dry the glass panel carefully.
When the cleaning is completed, do the
above steps in the opposite sequence.
Install the smaller panel first, then the larger
and the door.
WARNING! Make sure that the
glasses are inserted in the
correct position otherwise the
surface of the door may
overheat.
Replacing the lamp
Put a cloth on the bottom of the interior of
the appliance. It prevents damage to the
lamp glass cover and the cavity.
WARNING! Danger of
electrocution! Disconnect the
fuse before you replace the
lamp.
The lamp and the lamp glass
cover can be hot.
1. Deactivate the appliance.
2. Remove the fuses from the fuse box or
deactivate the circuit breaker.
The top lamp
1. Turn the lamp glass cover
counterclockwise to remove it.
2. Remove the metal ring and clean the
glass cover.
43