User manual
Table Of Contents
- CONTENTS
- SAFETY INFORMATION
- SAFETY INSTRUCTIONS
- PRODUCT DESCRIPTION
- CONTROL PANEL
- BEFORE FIRST USE
- DAILY USE
- CLOCK FUNCTIONS
- AUTOMATIC PROGRAMMES
- USING THE ACCESSORIES
- ADDITIONAL FUNCTIONS
- HINTS AND TIPS
- Advice for special heating functions of the oven
- Cooking with steam
- Steam water table
- Full Steam / ECO Steam
- Turbo Grilling and Full Steam in succession
- Half Steam + Heat
- Quarter Steam + Heat
- Baking
- Tips on baking
- Baking on one level:
- Bakes and gratins
- Moist Fan Baking
- Multilevel Baking
- Pizza Setting
- Roasting
- Roasting tables
- Grilling
- Frozen Foods
- Slow Cooking
- Defrost
- Preserving
- Drying
- Bread Baking
- Core temperature sensor table
- CARE AND CLEANING
- TROUBLESHOOTING
- TECHNICAL DATA
- ENERGY EFFICIENCY

shows that the temperature increases.
When temperature is reached the buzzer
sounds 3 times and the bar flashes and
then disappears.
Fast Heat Up Indicator
This function decreases the heat-up time.
Do not put food in the oven
when the Fast heat up function
operates.
To activate the function, hold for 3
seconds. The heat-up indicator alternates.
Residual heat
When you deactivate the appliance, the
display shows the residual heat. You can
use the heat to keep the food warm.
CLOCK FUNCTIONS
Clock functions table
Clock function Application
Minute Minder To set a countdown (max. 2 h 30 min). This
function has no effect on the operation of the
appliance. You can also activate it when the
appliance is deactivated.
Use to activate the function. Press or
to set the minutes and to start.
Duration To set the length of an operation (max. 23 h 59
min).
End Time To set the switch-off time for a heating function
(max. 23 h 59 min).
If you set the time for a clock function, the
time starts to count down after 5 seconds.
If you use the clock functions:
Duration, End Time, the
appliance deactivates the
heating elements after 90 % of
the set time. The appliance uses
the residual heat to continue the
cooking process until the time
ends (3 - 20 minutes).
Setting the clock functions
Before you use the functions:
Duration, End Time, you must
set a heating function and
temperature first. The appliance
deactivates automatically.
You can use the functions:
Duration and End Time at the
same time if you want to
automatically activate and
deactivate the appliance on a
given time later.
The functions: Duration and End
Time do not work when you use
the core temperature sensor.
1.
Set a heating function.
14