User manual

Problem Possible cause Solution
The lamp is defective. Refer to "Replacing the lamp".
The compressor operates
continually.
Temperature is set incor-
rectly.
Refer to "Operation" chapter.
Many food products were
put in at the same time.
Wait some hours and then
check the temperature again.
The room temperature is
too high.
Refer to climate class chart on
the rating plate.
Food products placed in
the appliance were too
warm.
Allow food products to cool to
room temperature before stor-
ing.
The door is not closed cor-
rectly.
Refer to "Closing the door".
DEMO appears on the dis-
play.
The appliance is in demon-
stration mode.
Keep the Mode pressed for ap-
proximately 10 seconds until a
long sound is heard and display
shuts off for a short time.
The temperature in the wine
cellar is too high.
There is no cold air circula-
tion in the appliance.
Make sure that there is cold air
circulation in the appliance.
The temperature regulator
is not set correctly.
Set a lower temperature.
The door is not closed cor-
rectly.
Refer to "Closing the door".
Many bottles are stored at
the same time.
Store less bottles at the same
time.
There is no cold air circula-
tion in the appliance.
"Make sure that there is cold air
circulation in the appliance.
If the advice does not lead to
the desired result, call the
nearest brand-mark service.
Replacing the lamp Wine Cellar
1. Disconnect the mains plug from the
mains socket.
2. Remove the lamp cover by pressing it
inwards with a tool (e.g. screwdriver) to
free the rear side hookings.
3. At the same time, free the middle hook
and slide off the cover in the direction of
the arrows.
21