Specifications

2
ENGLISH
Wall clock
How do I start the clock?
Automatic Set-Up
• Insert a battery (LR6, 1.5 V, Type AA) correctly into the battery compartment.
• The second hand will move to the 12 o’clock position, followed by the minute and hour hand.
• After receiving and processing the radio signal (3 to 12 minutes), the clock will automatically set itself
to the correct time.
• Please do not move the clock during this process.
• If the clock has not set itself after 12 minutes, your reception may be faulty or the signal cannot be
received at the chosen location.
• Repeat the set-up by choosing a different location and press the RESET button.
Manual Set-Up
• Press and hold the M.SET button for 3 seconds to enter manual setting mode.
• Press the M.SET button for 1 second to advance 1 minute.
• Press the M.SET button for more than 1 second to automatically advance the minute hand.
• If the M.SET button is not pressed for 8 seconds the clock is set to the displayed time.
Reset the clock
• Press the RESET button to reset the clock.
• The second hand will move to the 12 o’clock position, followed by the minute and hour hand.
• The clock will now start to receive the radio signal.
Safety precautions:
To reduce risk of electric shock, this product should ONLY be
opened by an authorized technician when service is required.
Disconnect the product from mains and other equipment if a
problem should occur. Do not expose the product to water or
moisture.
Maintenance:
Clean only with a dry cloth. Do not use cleaning solvents or abrasives.
Warranty:
No guarantee or liability can be accepted for any changes and modifications of the product or damage
caused due to incorrect use of this product.
General:
- Designs and specifications are subject to change without notice.
- All logos brands and product names are trademarks or registered trademarks of their respective
holders and are hereby recognized as such.
- This manual was produced with care. However, no rights can be derived. König Electronic can not
accept liability for any errors in this manual or their consequences.
- Keep this manual and packaging for future reference.
Attention:
This product is marked with this symbol. It means that used electrical and electronic products
should not be mixed with general household waste. There is a separate collections system for
these products.