User`s manual

to emulation port (not link to console directly) first and then boot it up.
Technical Specifications:
Functions
2 port Mini PS/2 KVM switch with
built-in two 6 feet 3-in-one cables
2 port Mini PS/2 KVM switch with
built-in two 6 feet 3-in-one cables
and Audio function
PC Port 2 2
Console Port 1 1
Audio port No 2
MAX PC Connections 2 2
Built-in KVM cable length
(Feet)
6 6
LED 2 2
PC Port cable connector
(All male Types)
PS/2 Keyboard Mini Din 6 pin
PS/2 Mouse Mini Din 6 pin
VGA HDDB 15pin
PS/2 Keyboard Mini Din 6 pin
PS/2 Mouse Mini Din 6 pin
3.5mm Audio Jack
3.5mm Microphone Jack
VGA HDDB 15pin
Console port connector
(All Female Types)
PS/2 Keyboard Mini Din 6 pin
PS/2 Mouse Mini Din 6 pin
VGA HDDB 15pin
PS/2 Keyboard Mini Din 6 pin
PS/2 Mouse Mini Din 6 pin
3.5mm Audio Jack
3.5mm Microphone Jack
VGA HDDB 15pin
PC selection Hot Key
Scan Intervals 8sec.
Keyboard Emulation PS/2
Mouse Emulation PS/2
VGA Resolution 2048X1536
Bandwidth 400MHz
Power Type Bus Bus
Housing Plastic Plastic
Size Mini Desktop Mini Desktop
Weight (g) 495 545
Dimension (mm)
Cable not include
87.11(L)X70.5(W)X28.09(H) 87.11(L)X70.5(W)X28.09(H)
System Requirements Specifications:
Functions
2 port Mini PS/2 KVM switch
2 port Mini PS/2 KVM switch
Console side One VGA Monitor
One PS/2 Keyboard
One PS/2 Mouse
One VGA Monitor
One PS/2 Keyboard
One PS/2 Mouse
One 3.5mm Speaker Jack
One 3.5 mm Microphone Jack
Computer Side No extra cable needed No extra cable needed
Product Details:
2 port Mini PS/2 KVM Switch
PC -1
PC -2
2 port Mini PS/2 KVM Switch with Audio
PC -1
PC -2
Hardware Installation:
Before installation, please make sure all of peripherals and computers have been turned off.
1. Connect the Keyboard, VGA, Mouse cables to the computer ports of KVM switch
2. Connect the Keyboard, VGA monitor, and Mouse to console port of KVM switch
3. After Powering on computers and finishing the boot-up process, you can start to use the
KVM switch.
Usage:
Normally, there is one LED is always lit (i.e. the console is connected to this PC port) for one PC
port and the other PC port’s LED is off, when you power on KVM switch.
When you select one of two PCs by Hot Key and it is shut down, the selected port LED flashed.
Keyboard Hot Key Commands:
You can also conveniently command KVM to switch ports through simple key sequences. To
send commands to KVM switch. The SCROLL LOCK key must be pressed twice within 2
seconds.
Note:
Please don’t switch the PC port (i.e. Don’t run hot-key command) during the
computers are under boot-up process.