Technical data

19740 Tablet PC Holder
INSTALLATION (A-I)
Continuation
F ATTACHING THE CRADLE
F 15 Place the cradle on the four hooks of the
F15swivel joint
F 16 Slide the cradle to the stop position (you will
F16hear a click)
G CLIP THE TABLET PC IN THE CRADLE
G 17 "Move the "small latch" upwards (click!)
G 17 - this allows the arm to be moved upwards
G 17 against a spring tension
G 18.a Hold the cradle firmly with one hand...
G 18.b ...align the tablet PC centrally in the
G 18.b clamping jaw and slide upwards until...
G 18.c ...the tablet PC can also be clipped into
G 18.c the lower side of clamping jaw
G 19 The spring tension of the arm will push the
G19tablet PC onto the four moss rubber
G19protectors of the clamping jaw
G 20 NOTE:
G20The tablet PC should sit neatly with the
G20guard arm. The position of the guard arm
G20may need to be corrected depending on the
G20size of the tablet PC. See I 25 ,26 & 28, 29.
G 21 Now slide the "small latch" down (click!) -
G21the upper jaws are now securely fixed
H REMOVING THE TABLET PC FROM THE CRADLE
H 22 Slide the "small latch" up again - the pull-out
H22section is now released
H 23 Hold the tablet PC and use it to push out
H23the top side of the cradle
H 24 Unclip the tablet-PC in a downwards motion
H24and remove
I DISMANTLING (Fig.re.)
I (e.g. to re-position the guard arm 5)
I 25 Release the lock between the tablet cradle
I25and the swivel joint as follows:
I 25.a Press the lever down and hold down
I 25.b Slide the tablet cradle upwards to stop
I 25.b approx. 6 mm
I 25.c Lift the tablet cradle
I 26 Remove the guard arm
I 27 If required, the supporting arm can also be
I27separated from the swivel joint by undoing
I27the wing screw
I DISMANTLING