Installation Manual

INSTALLATION INSTRUCTIONS
Continued
10. Install the provided tube mounting bracket
(083150) onto the air injection pump mounting
studs, reinstall the air injection pump and secure
with the factory mounting nuts from step #9.
11. Install the lter adapter into the heat shield and
secure with the provided hardware.
12. Install the provided edge trim onto the heat
shield as shown.
NOTE: Some trimming of the edge trim will be
necessary.
13. Remove two of the air box mounting grommets
from the factory air box.
14. Install the two air box mounting grommets into
the heat shield as shown.
15. Install the K&N
®
air lter onto the lter adapter
and secure with the provided hose clamp.
NOTE: Drycharger
®
air lter wrap; part #
RF-1041DK is available to purchase separately.
To learn more about Drycharger
®
lter wraps or
look up color availability please visit
http://www.knlters.com
®
.
16. Set the heat shield/lter assembly into position
so that the mounting grommets slide over the outer
air box mounting studs.
17. Remove the inlet air temperature sensor from
the factory intake tube.
NOTE: The sensor rotates counter clockwise
¼ turn and then pulls out. The inlet air
temperature sensor is very fragile.
18. Install the inlet air temperature sensor into the
K&N
®
intake tube as shown.
19. Install the provided ¼ npt vent tting into the
K&N
®
intake tube #27447 as shown.
NOTE: Plastic NPT ttings are easy to cross
thread. Install the vent tting “hand” tight, then
turn it two complete turns with a wrench.
20. Install the provided hump hose (084057) onto
to the lter adapter and secure with the provided
hose clamp.
21. Install the provided silicone hose (08690) onto
the throttle body and secure with the provided hose
clamp.
22. Slide the provided silicone hump hose (5-576)
all the way onto the K&N
®
intake tube #27446 as
shown.
23. Install the K&N
®
intake tube #27447 into the
silicone hose and onto the mounting bracket
so that the tube mounting studs align with the
mounting holes in the bracket. Secure the tube
with the provided hardware and hose clamp but
do not completely tighten at this time. Install the
K&N
®
intake tube #27446 into the throttle body’s
silicone hose and align the silicone hump hose with
the already installed K&N
®
intake tube. Slide the
silicone hose into position between the intake tubes
and secure with the provided hose clamps.
24. Reconnect the inlet air temperature sensor
electrical connection.
25. Measure the crank case vent tube 5” from the
end and then cut off the end with a knife.