Installation Manual

77-1560
TOOLS NEEDED:
NOTE: FAILURE TO FOLLOW INSTALLATION INSTRUCTIONS AND NOT USING THE PROVIDED HARDWARE
MAY DAMAGE THE INTAKE TUBE, THROTTLE BODY AND ENGINE.
PARTS LIST:
Description Qty. Part #
NOTE: This kit was not designed
to t vehicles with a body lift.
1. Turn off the ignition and disconnect the negative
battery cable.
NOTE: Disconnecting the negative battery cable
erases pre-programmed electronic memories.
Write down all memory settings before
disconnecting the negative battery cable. Some
radios will require an anti-theft code to be
entered after the battery is reconnected. The
anti-theft code is typically supplied with your
owner’s manual. In the event your vehicles’
anti-theft code cannot be recovered, contact an
authorized dealership to obtain your vehicles
anti-theft code.
TO START:
DODGE / JEEP
2011-14 Durango
2011-14 Grand Cherokee
V6-3.6L
2. Lift up the engine cover to unhook it from the
mounting grommets and then remove the engine
cover from the engine.
3. Disconnect the inlet air temperature sensor
electrical connection.
4. Disconnect the crank case vent tube from the air
box as shown.
5. Release the two clips that secure the upper air
box.
6. Remove the intake tube and upper air box from
the vehicle as shown.
NOTE: The intake tube is mounted in two
locations with grommets.
NOTE: Some models may have an EVAP
solenoid that needs to be disconnected.
7. Unhook the trim seal from the fresh air intake
scoop.
8. Lift up the lower air box to dislodge it from the
mounting grommets, then remove the lower air box
from the vehicle.
NOTE: K&N Engineering, Inc., recommends that
customers do not discard factory air intake.
9. Remove the two nuts that secure the air injection
pump to the mounting bracket. Gently set the air
injection pump aside.
Flat Blade Screwdriver
Ratchet
Extension
10mm Socket
4mm Allen Wrench
Pliers
Knife
A
A
B
A
C
D
E
F
K
L
H
I
G
J
J
E
E
N
N
J
J
I
P
Q
R
S
O
M
A Hose Clamp #52 3 08610
B Hose; 3-1/4” ID X 2”L Reinforced 1 08690
C Intake Tube (A) 1 27446-1
D Hose; Hump 3.25/3.50 X 3.00” 1 5-576
E Hose Clamp #56 3 08620
F Intake Tube (B) 1 27447
G Bolt, 6mm-1.00 X 16mm, SS 2 07812
H Bracket; Flat, STL, TB/PC 1 083150
I Washer, M6 Split Lock Zinc 4 1-3025
J Washer, 6mm Flat, SS 4 08269
K Hose; 5/8” ID X 9-3/4” L 1 084047
L Vent; STRT, 5/8 Barbed 1/4 NPT 1 08911
M Hose; 3-1/2” ID X 3”L Hump Molded 1 084057
N Bolt; M6 X 1.00 X 16mm, BtnHd. SS 2 07730
O Edge Trim 1 102480
P Heat Shield 1 074087
Q Adapter; Universal, 6” Filter 3.5” 1 21512-1
R Hose Clamp #104 1 08697
S Air Filter 1 RF-1041