Installation Manual

* FREE K&N
®
decal To register your warranty, please see us online at knlters.com/register. FREE K&N
®
decal *
INSTALLATION INSTRUCTIONS
Continued
ROAD TESTING:
21. It will be necessary for all K&N
®
high ow intake
systems to be checked periodically for realignment,
clearance and tightening of all connections.
Failure to follow the above instructions or proper
maintenance may void warranty.
20. Reconnect the vehicle’s negative battery cable.
Double check to make sure everything is tight and
properly positioned before starting the vehicle.
• 1455 CITRUS ST., P.O. BOX 1329, RIVERSIDE, CA., U.S.A. 92502 • TECH SERVICE 800-858-3333 • FAX [phone]
• e-mail: tech@knlters.com
®
• WWW: http://www.knlters.com
®
1. Start the engine with the transmission in neutral
or park, and the parking brake engaged. Listen for
air leaks or odd noises. For air leaks secure hoses
and connections. For odd noises, find cause and
repair before proceeding. This kit will function
identically to the factory system except for being
louder and much more responsive.
2. Test drive the vehicle. Listen for odd noises or
rattles and x as necessary.
3. If road test is ne, you can now enjoy the added
power and performance from your kit.
4. K&N Engineering, Inc., requires cleaning the
intake system’s air lter element every 100,000
miles. When used in dusty or off-road
environments, our lters will require cleaning more
often. We recommend that you visually inspect
your lter once every 25,000 miles to determine
if the screen is still visible. When the screen is no
longer visible some place on the lter element, it is
time to clean it. To clean and re-oil, purchase our
lter Recharger
®
service kit, part number 99-5050
or 99-5000 and follow the easy instructions.
19641A
2/3/14
10. Install the provided edge trim onto the heat
shield as shown.
NOTE: Some trimming of the edge trim will be
necessary.
11. Install the heat shield assembly into the engine
compartment and secure it to the rubber mounted
stud with the provided hardware.
12. Install the K&N
®
air lter onto the lter adapter
and secure with the provided hose clamp.
13. Install the heat shield mounting bracket
(064311) onto the heat shield and core support with
the provided hardware.
14. Install the coupling hose #08696 onto the
plenum and secure with the hose clamp.
15. Install the provided coupling hose #084055
onto the lter adapter as shown and secure with
the provided hose clamp.
16. Remove the pressure sensor from the factory
air box as shown.
17. Install the pressure sensor into the K&N
®
intake
tube and secure with the provided hardware.
18. Install the K&N
®
intake tube into the hose at the
plenum and then into the hose at the lter adapter
and then secure with the provided hose clamps.
19. Reconnect the pressure sensor electrical
connection.