Installation Manual
* FREE K&N
®
decal To register your warranty, please see us online at knlters.com/register. FREE K&N
®
decal *
INSTALLATION INSTRUCTIONS
Continued
ROAD TESTING:
32. It will be necessary for all K&N
®
high ow intake
systems to be checked periodically for realignment,
clearance and tightening of all connections.
Failure to follow the above instructions or proper
maintenance may void warranty.
30. Reconnect the vehicle’s negative battery cable.
Double check to make sure everything is tight and
properly positioned before starting the vehicle.
• 1455 CITRUS ST., P.O. BOX 1329, RIVERSIDE, CA., U.S.A. 92502 • TECH SERVICE 800-858-3333 • FAX 951-826-4001
• e-mail: tech@knlters.com
®
• WWW: http://www.knlters.com
®
28. Install the new air inlet tube into the stock air
inlet duct, then, line up the bracket with the hole on
the lower air cleaner assembly and secure with the
provided screw as shown.
NOTE: Before installing the inlet tube, inspect
the inside of the tube for any debris, then clean
the inside out with water and a towel. Inspect
the tube one more time before proceeding to
the next step.
29. Tighten the provided hose clamp on the air inlet
duct as shown.
1. Start the engine with the transmission in neutral
or park, and the parking brake engaged. Listen
for air leaks or odd noises. For air leaks secure
hoses and connections. For odd noises, find cause
and repair before proceeding. This kit will function
identically to the factory system except for being
louder and much more responsive.
2. Test drive the vehicle. Listen for odd noises or
rattles and x as necessary.
3. If road test is ne, you can now enjoy the added
power and performance from your kit.
4. K&N Engineering, Inc., requires cleaning the
intake system’s air lter element every 100,000
miles. When used in dusty or off-road
environments, our lters will require cleaning more
often. We recommend that you visually inspect
your lter once every 25,000 miles to determine
if the screen is still visible. When the screen is no
longer visible some place on the lter element, it is
time to clean it. To clean and re-oil, purchase our
lter Recharger
®
service kit, part number 99-5050
or 99-5000 and follow the easy instructions.
174023L
8/26/14
27. Reconnect the throttle body electrical
connection as shown.
26. Slide the battery terminal onto the locating tab
on the heat shield as shown.
25. Reconnect the stock crank case vent hose to
the vent on the intake tube as shown.
NOTE: On vehicles equipped with the second
vent line, connect the vent line to the tting
installed during step #19A. and secure with the
factory clamp.
31. The C.A.R.B. exemption sticker, (attached),
must be visible under the hood so that an
emissions inspector can see it when the vehicle
is required to be tested for emissions. California
requires testing every two years, other states may
vary.