Installation Manual

INSTALLATION INSTRUCTIONS
Continued
1. Start the engine with the transmission in neutral
or park, and the parking brake engaged. Listen for
air leaks or odd noises. For air leaks secure hoses
and connections. For odd noises, nd cause and
repair before proceeding. This kit will function iden-
tically to the factory system except for being louder
and much more responsive.
2. Test drive the vehicle. Listen for odd noises or
rattles and x as necessary.
3. If road test is ne, you can now enjoy the added
power and performance from your kit.
4. K&N Engineering, Inc., suggests checking the air
lter element periodically for excessive dirt build-
up. When the element becomes covered in dirt (or
once a year), service it according to the instructions
on the Recharger
®
service kit, part number 99-5050
or 99-5000
ROAD TESTING:
* FREE K&N
®
decal To register your warranty, please see us online at knlters.com/register. FREE K&N
®
decal *
• 1455 CITRUS ST., P.O. BOX 1329, RIVERSIDE, CA., U.S.A. 92502 • TECH SERVICE 800-858-3333 • FAX [phone]
• e-mail: tech@knlters.com
®
• WWW: http://www.knlters.com
®
10. Install the K&N
®
air lter onto the mass air
sensor inside the heat shield and secure with the
provided hose clamp.
NOTE: Drycharger
®
air lter wrap; part number
RX-4990DK is available to purchase separately.
To learn more about Drycharger
®
lter wraps
or look up color availability please visit http://
www.knlters.com
®
.
11. Install the provided silicone hose (08440) onto
the mass air sensor and secure with the provided
hose clamp.
12. Remove two of the upper airbox mounting
screws from the upper airbox.
13. Install the heat shield assembly onto the lower
airbox. Secure the heat shield assembly to the
lower airbox with the two screws removed from the
upper airbox in step #12.
14. Install the silicone hose (08484) onto the turbo
inlet and secure with the provided hose clamp.
15. Install the K&N
®
intake tube into the silicone
hoses on the turbo inlet and mass air sensor and
then secure with the provided hose clamp.
16. Install the crankcase vent hose into the silicone
hose at the turbo inlet and secure with the provided
hose clamp.
17. Reconnect the mass air sensors electrical
connection.
19. The C.A.R.B. exemption sticker, (attached),
must be visible under the hood so that an emis-
sions inspector can see it when the vehicle is
required to be tested for emissions. California
requires testing every two years, other states may
vary.
18. Reconnect the vehicle’s negative battery cable.
Double check to make sure everything is tight and
properly positioned before starting the vehicle.
18586F
8/14/14
19. It will be necessary for all K&N
®
high ow intake
systems to be checked periodically for realignment,
clearance and tightening of all connections. Failure
to follow the above instructions or proper mainte-
nance may void warranty.