Installation Manual

* FREE K&N
®
decal To register your warranty, please see us online at knlters.com/register. FREE K&N
®
decal *
INSTALLATION INSTRUCTIONS
Continued
ROAD TESTING:
22. It will be necessary for all K&N
®
high ow intake
systems to be checked periodically for realignment,
clearance and tightening of all connections.
Failure to follow the above instructions or proper
maintenance may void warranty.
20. Reconnect the vehicle’s negative battery cable.
Double check to make sure everything is tight and
properly positioned before starting the vehicle.
19. Reconnect the mass air sensor electrical
connection.
• 1455 CITRUS ST., P.O. BOX 1329, RIVERSIDE, CA., U.S.A. 92502 • TECH SERVICE 800-858-3333 • FAX [phone]
• e-mail: tech@knlters.com
®
• WWW: http://www.knlters.com
®
1. Start the engine with the transmission in neutral
or park, and the parking brake engaged. Listen for
air leaks or odd noises. For air leaks secure hoses
and connections. For odd noises, find cause and
repair before proceeding. This kit will function
identically to the factory system except for being
louder and much more responsive.
2. Test drive the vehicle. Listen for odd noises or
rattles and x as necessary.
3. If road test is ne, you can now enjoy the added
power and performance from your kit.
4. K&N Engineering, Inc., requires cleaning the
intake system’s air lter element every 100,000
miles. When used in dusty or off-road
environments, our lters will require cleaning more
often. We recommend that you visually inspect
your lter once every 25,000 miles to determine
if the screen is still visible. When the screen is no
longer visible some place on the lter element, it is
time to clean it. To clean and re-oil, purchase our
lter Recharger
®
service kit, part number 99-5050
or 99-5000 and follow the easy instructions.
19638B
9/08/14
7. Cut the provided edge trim into two sections,
one section will be 27” long and one section will be
14-1/2” long.
8. Install the edge trim into the hole and around the
outside of the heat shield as shown.
9. Install the heat shield onto the factory air box
mounting locations and secure with the provided
hardware.
10. Install the provided silicone hose (084014) onto
the throttle body and secure with the provided hose
clamp.
11. Remove the two screws securing the mass air
sensor and then remove the mass air sensor from
the vehicle.
12. Install mass air sensor into the K&N
®
intake
tube and secure with the provided hardware.
13. Remove the bolt shown from the engine; this
bolt will be reused in the next step.
14. Install the provided tube mounting bracket
(064308) onto the engine as shown using the bolt
from the previous step.
15. Install the K&N
®
intake tube through the heat
shield, into the silicone hose at the throttle body
and align with the mounting bracket. Secure the
tube with the provided hardware and hose clamp.
16. Cut the provided crank case vent hose to a
length of 1-1/2” long as shown.
17. Connect the factory crank case vent pipe to the
K&N
®
intake tube using the 1-1/2” long section of
crank case vent hose from the previous step.
18. Install the K&N
®
air lter onto the K&N
®
intake
tube and secure with the provided hose clamp
21. The C.A.R.B. exemption sticker, (attached),
must be visible under the hood so that an
emissions inspector can see it when the vehicle
is required to be tested for emissions. California
requires testing every two years, other states may
vary.