Installation Manual

INSTALLATION INSTRUCTIONS
Continued
9. Remove the turbo inlet tube mounting
bolt shown.
NOTE: This bolt secures the turbo inlet
tube to the intercooler.
10. Remove the transmission mount bolt
shown.
NOTE: This bolt will be reused in a later
step.
11. Install supplied short edge trim into the
hole of the heat shield as shown.
NOTE: Some trimming of the edge trim
may be necessary.
12. Install the long edge trim around
the outside of the heat shield as shown.
NOTE: Some trimming of the edge trim
may be necessary.
13. Install the “L” bracket (070097) onto
the heat shield with the provided
hardware.
14. Install the heat shield assembly into
the vehicle and secure to the engine
mount using the bolt removed during step
#10.
15. Secure the heat shield mounting
bracket to the lower airbox mounting tab
using the bolt removed in step #7.
NOTE: Be sure to place the provided
spacer between the bracket and
mounting tab.
16. Install the provided silicone hose
(08711) onto the turbo inlet tube and
secure with the provided hose clamp.
17. Install the supplied tube mounting
bracket (070098) onto the K&N
®
intake
tube using the provided hardware.
18. Remove the two mass air sensor
retaining bolts and the remove the mass
air sensor from the stock air lter
housing.
19. Install the mass air sensor into the
K&N
®
intake tube and secure with the
provided hardware.
20. Install the K&N
®
intake tube into the
silicone hose at the turbo inlet tube and
align so the mounting bracket lines up with
the turbo inlet mounting location. Secure
the intake tube with the hose clamp and
hardware provided.
21. Install the K&N
®
air lter onto the
intake tube and secure with the provided
hose clamp.
22. Reconnect the mass air sensor
electrical connection.
23. Reinstall the engine cover and secure
with the factory quarter turn fasteners.