Installation Manual

INSTALLATION INSTRUCTIONS
Continued
10. Install the lter adapter into the heat shield and
secure with the provided hardware.
11. Install the provided edge trim onto the heat
shield as shown.
NOTE: Some trimming of the edge trim will be
necessary.
12. Install the provided inserted nut onto the heat
shield mounting bracket and secure with the
provided hardware.
NOTE: Do not completely tighten at this time.
14. Install the provided silicone hose (5-576) onto
the lter adapter as shown and secure with the
provided hose clamp.
15. Install the heat shield assembly into the vehicle
so the inserted nut goes into the air box mounting
grommet hole and the tab goes onto the air box
mounting stud. Secure the heat shield with the
provided hardware.
13. Install the provided rubber fender washer onto
the outer air box mounting stud.
20. Install the provided vent tting into the K&N
®
intake tube as shown.
NOTE: Plastic NPT ttings are easy to cross
thread. Install the vent tting “hand” tight, then
turn it two complete turns with a wrench.
18. Install the mass air sensor into the mass air
sensor adapter and secure with the provided
hardware.
NOTE: Vehicle’s MAF sensor may vary among
model years, reference appropriate image
above.
19. Install the mass air sensor assembly into the
K&N
®
intake tube as shown and secure with the
provided hardware.
NOTE: The opening of the mass air sensor is to
be pointed towards the inlet side of the tube as
shown in photo.
NOTE: Vehicle’s MAF sensor may vary among
model years, reference appropriate image
above.
17. Remove the two screws that secure the mass
air sensor into the factory intake tube.
NOTE: Vehicle’s MAF sensor may vary among
model years, reference appropriate image
above.
16. Install the provided gasket onto the mass air
sensor adapter.
NOTE: Vehicle’s MAF sensor may vary among
model years, use appropriate gasket and mass
air sensor adapter.
21. Install the provided silicone hose (08629) onto
the K&N
®
intake tube as shown. Install the K&N
®
intake tube assembly onto the throttle body and
hump hose attached to the lter adapter. Adjust the
intake tube in the hoses for proper t, once proper
t is achieved secure the tube with the provided
hose clamps.
9. Install the heat shield mounting bracket (083126)
onto the heat shield and secure with the provided
hardware.