Owners manual

INSTALLATION INSTRUCTIONS
Continued
10. Remove the lower airbox from the vehicle.
NOTE: K&N Engineering, Inc., recommends that
customers do not discard factory air intake.
11. Install the two rubber mounted studs onto the
heat shield using the provided hardware as shown.
12. Install the heat shield mounting bracket
(070902) onto the heat shield using the provided
hardware and spacers as shown.
13. Install the provided heat shield mounting
bracket (07190) onto the heat shield using the
provided hardware and spacer as shown.
14. Install the provided heat shield mounting
bracket (070742) onto the heat shield using the
provided hardware and spacer as shown.
15. Install the tube mounting bracket (083152)
onto the rubber mounted studs as shown using the
provided hardware.
16. Install the provided shorter edge trim into the
hole of the heat shield as shown.
NOTE: Trimming of the edge trim will be
necessary.
17. Install the provided longer edge trim onto the
heat shield as shown.
NOTE: Trimming of the edge trim will be
necessary.
18. Remove the bolt that secures the ground strap
to the inner fender.
NOTE: This bolt will be reused.
19. Set the heat shield into position on the inner
fender and then secure with the factory bolt
removed in step #18 and the provided hardware.
NOTE: Be sure to place the ground strap
between the inner fender and bracket.
20. Remove the mass air sensor from the factory
airbox.
21. Install the mass air sensor into the K&N
®
intake
tube and secure with the provided hardware.
22. Install the provided NPT ttings into the K&N
®
intake tube as shown.
NOTE: Plastic NPT ttings are easy to cross
thread. Install the vent tting “hand” tight, then
turn it two complete turns with a wrench.
23. Install the provided silicone hose (08050)
onto the throttle body as shown, secure with the
provided hose clamp.
24. Install the K&N
®
intake tube into the silicone
hose at the throttle body and align with the
mounting bracket attached to the heat shield.
Secure the intake tube with the provided hardware
and hose clamp.
25. Install the provided lter adapter into the K&N
®
air lter and secure with the hose clamp.
NOTE: Drycharger
®
air lter wrap; part #
RF-1042DK is available to purchase separately.
To learn more about Drycharger
®
lter wraps or
look up color availability please visit
http://www.knlters.com
®
.
26. Install the silicone hose (08625) onto the lter
adapter and secure with the provided hose clamp.
27. Install the lter assembly onto the K&N
®
intake
tube and secure with the provided hose clamp.