Owners manual

INSTALLATION INSTRUCTIONS
Continued
7. Pull rmly upwards to release the air cleaner
assembly from the mounting tray grommets, and
then remove the assembly as shown.
NOTE: K&N Engineering, Inc., recommends that
customers do not discard factory air intake.
8. Loosen the hose clamp and remove the mass air
sensor from the air cleaner as shown.
9. Install the lter adapter onto the heat shield and
secure with the provided hardware.
10. Install the “L” bracket (010031) onto the heat
shield with the provided hardware as shown.
11. Install the provided edge trim onto the heat
shield as shown.
NOTE: some trimming of the edge trim mat be
necessary.
12. Remove the two air box mounting grommets
shown.
NOTE: Some vehicles may not be equipped
with the front grommet and hole. Go to step 13.
13. On vehicles not equipped with the front air
box mounting grommet and hole, install the heat
shield assembly as shown. Then use a marker to
mark the mounting plate through the heat shield
mounting hole.
14. Remove the heat shield assembly and drill a
5/8”id hole through the marked location from step
#13.
15. Install the two 5/16”inserted nuts into the air
box mounting tray as shown.
16. Install the heat shield assembly onto the air
box-mounting tray and secure to the 5/16” inserted
nuts with the provided hardware as shown.
17. Secure the heat shield mounting bracket to
the inner fender with the two fender washers and
hardware as shown.
18. Install the silicone hose (08618) onto the lter
adapter and secure with the provided hose clamp.
19. Install the silicone (08050) hose onto the
throttle body and secure with the provided hose
clamp.
20. Install the mass air sensor assembly into the
silicone hose on the lter adapter and secure with
provided hose clamp.
21. Install the silicone hump hose (08543) onto the
mass air sensor and secure with the provided hose
clamp as shown.
22. Install the “L” bracket (070812) onto the K&N
®
intake tube with the provided hardware as shown.
23. Install the K&N
®
intake tube into the silicone
hose at the throttle body and mass air sensor and
secure with the provided hose clamps.
24. Install the upper radiator hose mount onto the
mounting bracket installed onto the K&N
®
intake
tube.