Owners manual

INSTALLATION INSTRUCTIONS
Continued
7. Unhook the coolant pipe from the intake tube.
8. Loosen the hose clamp which secures the intake
tube to the engine inlet then remove the intake tube
from the vehicle.
9. Remove the bolt securing the lower air box to
the battery tray.
10. Remove the lower air box from the vehicle.
NOTE: K&N Engineering, Inc., recommends that
customers do not discard factory air intake.
11. Remove the two bolts which secure the air box
mounting bracket to the core support and inner
fender.
12. Remove the air box mounting bracket from the
vehicle.
13. Unhook the wiring harness from the fresh air
intake duct.
14. Remove the 5 bolts and one push pin securing
the front of the inner fender panel and then pull
the inner fender panel back to gain access to the
bottom of the fresh air intake duct.
15. Remove the two clips shown that retain the
bottom of the fresh air intake duct.
16. Remove the push pin securing the top of the
fresh air intake duct.
17. Unhook the wiring harness secured to the core
support through the fresh air intake duct.
18. Remove the fresh air intake duct from the
vehicle. Secure the inner fender to the vehicle with
the original hardware from step #15.
19. Install the two heat shield stand-os onto the
heat shield as shown using the provided hardware.
20. Install the lter adapter into the heat shield
using the provided hardware.
21. Install the factory air box mounting bracket
onto the heat shield as shown so that the mount
stand-os installed in step #20 snap into the factory
mounting grommets.
22. Install the provided edge trim onto the heat
shield as shown.
NOTE: Some trimming of the edge trim will be
necessary.
23. Set the heat shield assembly into position and
secure with the factory mounting hardware from
step #12.
NOTE: Start the bolt going into the inner fender
panel rst, and then install the bolt attaching to
the core support, then tighten both bolts. Take
car lowering the heat shield into position as it
will be very close to the positive battery cable.
The negative battery cable should have been
disconnected in step #1 to prevent any possible
arcing.
24. Install the silicone hump hose (08418) onto the
lter adapter and secure with the provided hose
clamp.