Owners manual

* FREE K&N
®
decal To register your warranty, please see us online at knlters.com/register. FREE K&N
®
decal *
INSTALLATION INSTRUCTIONS
Continued
ROAD TESTING:
32. It will be necessary for all K&N
®
high ow intake
systems to be checked periodically for realignment,
clearance and tightening of all connections.
Failure to follow the above instructions or proper
maintenance may void warranty.
• 1455 CITRUS ST., P.O. BOX 1329, RIVERSIDE, CA., U.S.A. 92502 • TECH SERVICE 800-858-3333 • FAX [phone]
• e-mail: tech@knlters.com
®
• WWW: http://www.knlters.com
®
30. Reconnect the vehicle’s negative battery cable.
Double check to make sure everything is tight and
properly positioned before starting the vehicle.
1. Start the engine with the transmission in neutral
or park, and the parking brake engaged. Listen for
air leaks or odd noises. For air leaks secure hoses
and connections. For odd noises, find cause and
repair before proceeding. This kit will function
identically to the factory system except for being
louder and much more responsive.
2. Test drive the vehicle. Listen for odd noises or
rattles and x as necessary.
3. If road test is ne, you can now enjoy the added
power and performance from your kit.
4. K&N Engineering, Inc., requires cleaning the
Blackhawk Induction
TM
intake system’s air lter
element every 100,000 miles. When used in dusty
or o-road environments, our lters will require
cleaning more often. We recommend that you
visually inspect your lter once every 25,000 miles
to determine if the screen is still visible. When the
screen is no longer visible some place on the lter
element, it is time to clean it. To clean, purchase
our Synthetic Filter Cleaner, part number 99-0624
and follow the easy instructions.
175095A
2/13/18
25. Install the provided coupling hose (08698) onto
the throttle body and secure with the provided hose
clamp.
26. Install the intake tube into the heat shield and
coupling hose at the throttle body then secure the
tube with the hose clamp and hardware,
27. Install the provided crank case vent hose onto
the valve cover port and then connect the open end
to the intake tube.
28. Connect the provided extension harness to the
factory inlet air temperature sensor harness and
then connect the open end to the sensor installed
into the K&N
®
intake tube.
29. Install the air lter and secure with the provided
hose clamp.
31. The C.A.R.B. exemption sticker, (attached),
must be visible under the hood so that an
emissions inspector can see it when the vehicle
is required to be tested for emissions. California
requires testing every two years, other states may
vary.