Owners manual

INSTALLATION INSTRUCTIONS
Continued
7. Remove the intake plenum and throttle body
seal from the vehicle.
8. Release the spring clamp and then disconnect
the crank case vent hose from the breather port.
9. Remove the front 6 bolts securing the inner
fender and lower the inner fender to gain access to
the air lter mounting bracket.
10. Remove the four bolts that secure the air lter
mounting bracket and then remove the bracket
from the vehicle.
11. Reinstall the inner fender and secure with the
original hardware.
12. Remove the bolt show which secures the ECU
harness bracket to the inner fender.
13. Install the two of the rubber mounted studs onto
the provided bracket (070050) and secure with the
provided hardware.
14. Install the bracket assembly onto the inner
fender and secure with the bolt removed in step
#12.
15. Install one of the provided rubber mounted
studs onto the inner fender and secure with the
provided hardware.
16. Install the provided edge trim onto the heat
shield as shown.
NOTE: Some trimming of the edge trim will be
necessary.
17. Install two of the provided rubber mounted
studs onto the provided bracket (070048) and
secure with the provided hardware.
18. Install the bracket assembly onto the heat
shield and secure with the provided hardware.
19. Install the heat shield assembly into the vehicle
and secure to the bracket previously installed, to
the inner fender and rubber mounted stud.
20. Install the nal rubber mounted stud onto the
intake tube as shown.
21. Install the tube mounting bracket (070049) onto
the rubber mounted stud as shown.
22. Install the silicone hose into the inlet air
temperature sensor mount as shown.
23. Remove the inlet temperature sensor from the
intake plenum and then remove the O-ring from the
sensor.
24. Install the inlet air temperature sensor into the
silicone hose installed in step #21.