Owners manual

Q
P
P
I
I
H
H
H
I
I
J
E
F
G
G
G G
G
D
A
B
A
C
K
L
M
R
N
O
O
O
Q
®
69-8757TTK
TOOLS NEEDED:
NOTE: EXCLUDES ECO MODELS
NOTE: FAILURE TO FOLLOW INSTALLATION INSTRUCTIONS AND NOT USING THE PROVIDED HARDWARE
MAY DAMAGE THE INTAKE TUBE, THROTTLE BODY AND ENGINE.
TO START:
Description Qty. Part #
2. Pull up rmly to dislodge the engine cover from
the mounting grommets and then remove the cover
from the engine.
3. Disconnect the crank case vent hose from the
valve cover port as shown.
4. Disconnect the mass air sensor electrical
connection. Then unhook the mass air sensor wiring
harness from the upper air box.
5. Loosen the hose clamp which secures the intake
tube to the throttle body.
6. Unclip the upper air box retaining clips and then
remove the upper air box and intake assembly.
7. Remove the three lower air box retaining bolts.
Then unclip the wiring harness from the rear of the
air box and remove the lower air box housing from
the vehicle.
NOTE: K&N Engineering, Inc., recommends that
customers do not discard factory air intake.
8. Remove the bolt shown which secures the engine
wiring harness to the engine.
NOTE: This bolt will be reused.
9. Install the two heat shield mounting brackets
(070052) onto the air box mounting bracket as
shown.
NOTE: Be sure to install the brackets 180º or in
the opposite direction from each other.
phillips screwdriver
3mm allen wrench
10mm socket
12mm socket
10mm wrench
extension
ratchet
2009-16 Corolla
L4-1.8L
TOYOTA
A Hose Clamp #40 2 08554
B Hose; 2-1/2” To 2-3/4” Tprd., Blk. 1 084016
C Intake Tube 1 27555-1TTK
D Cable Tie; 11” Blk. 1 21590
E Hose; 5/8”ID X 20”L, Blk. Silicone 1 08542
F Bracket; “L”, Stl., FB/PC 1 070110
G Washer; 1/4”ID X 5/8”OD - SAE 5 08275
H Washer; 1/4” Lock, ZN 3 08198
I Bolt; 6MM-1.00 X 16MM, SS 5 07812
J Bolt; M4 - 0.07 8MM, A/H Cap., SS 2 07733
K Hose Clamp #44 1 08577
L Edge Trim (17”) 1 102469
M Edge Trim (56”) 1 102490
N Heat Shield 1 074048
O Washer; 1.25D X. 28 HOL ZN 4 08151
P Nut; 6MM Nylock, Hex Head, SS 2 07512
Q Bracket; “C”, Stl., FB/PC 2 070052
R Air Filter 1 RU-4960XD
PARTS LIST:
1. Turn off the ignition and disconnect the negative
battery cable.
NOTE: Disconnecting the negative battery cable
erases pre-programmed electronic memories.
Write down all memory settings before
disconnecting the negative battery cable. Some
radios will require an anti-theft code to be
entered after the battery is reconnected. The
anti-theft code is typically supplied with your
owners manual. In the event your vehicles’
anti-theft code cannot be recovered, contact an
authorized dealership to obtain your vehicles
anti-theft code.

Summary of content (2 pages)