Owners manual

INSTALLATION INSTRUCTIONS
Continued
28. Remove the valve cover mounting bolt
shown.
29. Install the K&N
®
intake tube into the silicone
hose at the throttle body and align the bracket to
the valve cover, secure with the factory valve cover
bolt and hose clamp.
30. Reconnect the crank case vent hose to the
tting and secure with the factory hose clamp.
33. Reinstall the fresh air supply and secure with
the factory bolt removed in step #6.
27. Install the silicone hose onto the throttle body
and secure with the provided hose clamp.
31. Using a small screw driver, remove the mass
air sensor plastic elbow cover and then reconnect
the mass air sensor electrical connection.
32. Install the K&N
®
air lter onto the intake tube
and then tighten the hose clamp.
NOTE: Drycharger
®
air lter wrap; part #
RX-4990DK is available to purchase separately.
To learn more about Drycharger
®
lter wraps or
look up color availability please visit
http://www.knlters.com
®
.
* FREE K&N
®
decal To register your warranty, please see us online at knlters.com/register. FREE K&N
®
decal *
34. Reinstall the air lter cover and secure with the
factory retainers.
35. Reinstall the front cover and secure with the
factory retainers.
36. Reinstall the engine cover onto the top of the
engine.
37. Reconnect the vehicle’s negative battery cable.
Double check to make sure everything is tight and
properly positioned before starting the vehicle.
18874G
5/25/16
38. It will be necessary for all K&N
®
intake kits to
be checked periodically for realignment, clearance
and tightening of all connections. Failure to follow
the above instructions or proper maintenance may
void warranty.
• 1455 CITRUS ST., P.O. BOX 1329, RIVERSIDE, CA., U.S.A. 92502 • TECH SERVICE 800-858-3333 • FAX 951-826-4001
• e-mail: tech@knlters.com
®
• WWW: http://www.knlters.com
®
ROAD TESTING:
1. Start the engine with the transmission in neutral
or park, and the parking brake engaged. Listen for
air leaks or odd noises. For air leaks secure hoses
and connections. For odd noises, find cause and
repair before proceeding. This kit will function
identically to the factory system except for being
louder and much more responsive.
2. Test drive the vehicle. Listen for odd noises or
rattles and x as necessary.
3. If road test is ne, you can now enjoy the added
power and performance from your kit.
4. K&N Engineering, Inc., requires cleaning the
intake system’s air lter element every 100,000
miles. When used in dusty or off-road
environments, our lters will require cleaning more
often. We recommend that you visually inspect
your lter once every 25,000 miles to determine
if the screen is still visible. When the screen is no
longer visible some place on the lter element, it is
time to clean it. To clean and re-oil, purchase our
lter Recharger
®
service kit, part number 99-5050
or 99-5000 and follow the easy instructions.