Owners manual

INSTALLATION INSTRUCTIONS
Continued
13. Install the edge trim onto the heat shield as
shown.
14. Install the rubber mounted stud onto the heat
shield as shown.
15. Install the “L” bracket (020001) onto the rubber
mounted stud as shown.
18. Install the rubber mounted stud into the relay
mounting bracket as shown.
11. Loosen the hose clamp that secures the stock
intake tube to the throttle body.
12. Remove the complete intake assembly.
NOTE: Unhook the vacuum lines clipped onto
the intake tube.
NOTE: K&N
®
recommends that customers do
not discard factory air intake.
16.Install the “Z” bracket (020003) onto the heat
shield as shown.
17. Remove the relay bracket mounting bolt
shown.
19. Remove the ground strap bolt shown.
20. Install the fender washer and rubber washer
onto the air box mounting point on the core support
as shown.
21. Set the heat shield into position and align with
the rubber mounted stud, fender washer, and
the ground strap bracket. Secure with provided
hardware.
NOTE: Be sure to use the provide spacer on top
of the ground strap.
22. Remove the screws that secure the mass air
sensor into the stock air lter housing and then
remove the mass air sensor.
23. Install the mass air sensor into the K&N
®
intake
tube with provided bolts.
24. Remove the crank case vent chamber from the
stock intake tube as shown.
25. Install the silicone hose onto the K&N
®
intake
tube crank case vent as shown and secure with the
hose clamp, then install the factory crank case vent
chamber into the silicone hose and secure with the
hose clamp as shown.
26. Install the “Z” (070992) onto the K&N
®
intake
tube as shown.
NOTE: the twist side of the bracket should be
bolted to the tube.
10. Loosen and remove the three air box mounting
bolts shown.