Owners manual

ManualsBrandsK&N Filters ManualsAutomotive69-8702TP Typhoon Complete Cold Air Induction Kit Fits 07-11 GS350

69-8702TP

LEXUS

2007-11 GS350

V6-3.5L

TOOLS NEEDED:

NOTE: FAILURE TO FOLLOW INSTALLATION INSTRUCTIONS AND NOT USING THE PROVIDED HARDWARE

MAY DAMAGE THE INTAKE TUBE, THROTTLE BODY AND ENGINE.

2. Pull rmly up on the engine cover and remove

the cover from the engine as shown.

3. Depress the center locking button to release

seven core support fasteners.

4. Remove the seven fasteners, then remove the

cover from the core support.

5. Depress the center locking button on the two air

lter cover fasteners, remove the two fasteners and

unscrew plastic screw shown. Then remove the

cover from the vehicle.

6. Remove the bolt that secures the fresh air

supply to the core support.

7. Remove the fresh air supply from the core

support as shown.

TO START:

A HOSE CLAMP #44 1 08560

B HOSE; 3” ID 3-1/8ID X 2”L TPRD 1 084031

C HOSE CLAMP #48 2 08601

D TUBE 3” OD 1 27513TP

E HOSE; 1-1/8” ID X 2”L 1 084074

F HOSE CLAMP #16 2 08413

G BOLT; M4-0.07 8MM SS 2 07733

H BRACKET; “Z” 1 020003

I BOLT; M6-1.0 X 12MM SS 4 07727

J WASHER; 6MM WAVE SS 8 08277

K HEAT SHIELD 1 07341

L EDGE TRIM; 39” L 1 102496

M BRACKET; “Z” 1 070992

N BOLT; M6-1.0 X 20MM SS 1 07795

O SPACER; .625” OD X .250” ID 1 06555

P NUT; 6MM NYLOCK 2 07512

Q STUD; RUBBER MNT 2 070228

R BRACKET; “L” 1 020001

S BOLT; M6-1.0 X 16MM SS 1 07703

T WASHER; 1” D X 1/4 HOLE FENDER 1 08160

U WASHER; 1” X 3.00 RUBBER 1 21685

V AIR FILTER 1 RU-4990

Description Qty. Part # Description Qty. Part # Description Qty. Part #

PARTS LIST:

8. Disconnect the mass air sensor electrical

connection and unhook the wiring harness from the

air box.

9. Unhook the crank case vent hose from the tting

in the stock intake tube.

ratchet

extension

10mm socket

10mm wrench

3mm allen wrench

at head screwdriver

phillips head screwdriver

pliers

1. Turn off the ignition and disconnect the negative

battery cable.

NOTE: Disconnecting the negative battery cable

erases pre-programmed electronic memories.

Write down all memory settings before

disconnecting the negative battery cable. Some

radios will require an anti-theft code to be

entered after the battery is reconnected. The

anti-theft code is typically supplied with your

owner’s manual. In the event your vehicles

anti-theft code cannot be recovered, contact an

authorized dealership to obtain your vehicles

anti-theft code.

Summary of content (3 pages)

PAGE 1
® 69-8702TP LEXUS 2007-11 GS350 V6-3.5L A B F L E C D F G I J K O J M J TOOLS NEEDED: ratchet extension 10mm socket 10mm wrench 3mm allen wrench flat head screwdriver phillips head screwdriver pliers N J I H I J I P R Q J J P Q S J C V T U PARTS LIST: Description A B C D E F G H HOSE CLAMP #44 HOSE; 3” ID 3-1/8ID X 2”L TPRD HOSE CLAMP #48 TUBE 3” OD HOSE; 1-1/8” ID X 2”L HOSE CLAMP #16 BOLT; M4-0.07 8MM SS BRACKET; “Z” Qty.
PAGE 2
Continued INSTALLATION INSTRUCTIONS 10. Loosen and remove the three air box mounting bolts shown. 16.Install the “Z” bracket (020003) onto the heat shield as shown. 11. Loosen the hose clamp that secures the stock intake tube to the throttle body. 17. Remove the relay bracket mounting bolt shown. 12. Remove the complete intake assembly. NOTE: Unhook the vacuum lines clipped onto the intake tube. NOTE: K&N® recommends that customers do not discard factory air intake. 18.
PAGE 3
INSTALLATION INSTRUCTIONS Continued 27. Install the silicone hose onto the throttle body and secure with the provided hose clamp. 28. Remove the valve cover mounting bolt shown. 31. Using a small screw driver, remove the mass air sensor plastic elbow cover and then reconnect the mass air sensor electrical connection. 32. Install the K&N® air filter onto the intake tube and then tighten the hose clamp. NOTE: Drycharger® air filter wrap; part # RX-4990DK is available to purchase separately.