Owners manual

INSTALLATION INSTRUCTIONS
Continued
11. Install the ½” high rubber mounted stud
onto the rear air box mounting location using the
provided hardware.
12. Remove the lower-front throttle body mounting
bolt.
NOTE: This bolt will be reused in the next step.
13. Install the tube mounting bracket (070091)
onto the throttle body using the bolt removed in the
previous step.
14. Install the provided silicone hose (084036)
onto the throttle body and secure with the provided
hose clamp.
15. Install the provided ¼”npt vent tting into the
K&N
®
Intake Tube as shown.
NOTE: Plastic NPT ttings are easy to cross
thread. Install the vent tting “hand” tight, then
turn it two complete turns with a wrench.
16. Remove the two bolts which secure the mass
sensor to the intake tube and remove the mass air
sensor as shown.
17. Install the mass air sensor into the K&N
®
intake
tube and secure with the provided hardware.
18. Install the K&N
®
intake tube into the silicone
hose at the throttle body and align with the
mounting bracket. Secure with the provided
hardware and hose clamp.
19. Install the heat shield mounting bracket
(010051) onto the heat shield as shown using the
provided hardware.
NOTE: On vehicles equipped with manual
transmissions use bracket (070015)
20. Install the provided edge trim onto the heat
shield as shown.
NOTE: Some trimming of the edge trim will be
necessary.
21. Install the heat shield into the vehicle so the
mounting holes line up with the rubber mounted
studs installed earlier. Secure the heat shield and
mounting bracket with the hardware provided.
22. Reinstall the fresh air inlet supply to the
original location and into the fresh air tube on the
heat shield then secure with the factory bolts.
23. Install the factory crank case vent hose to the
¼” npt vent installed onto the K&N
®
intake tube.
24. Reconnect the mass air sensor electrical
connection.
10. Install the 1.0” high rubber mounted stud onto
the front air box mounting location using the
provided hardware.