Owners manual

INSTALLATION INSTRUCTIONS
Continued
7. Release the spring clamp and then remove the
BOV hose from BOV.
8. Remove the two bolts that secure the inner fresh
air duct to the core support and then remove the
inner fresh air duct.
NOTE: The two bolts are hidden from view
under the top lip of the core support.
9. Remove the cover from the hose clamp screw
on the throttle body charge hose.
NOTE: The cap is pressed on and can be pried
o with a small screw driver.
10. Loosen the hose clamp securing the intake
charge tube and then remove it from the throttle
body. Loosen and remove the two upper throttle
body bolts shown.
11. Install the provided tube mounting bracket
using the factory throttle body bolts removed in the
previous step, Reinstall the intake charge hose and
secure with the factory hose clamp.
12. Install the provided coupling hose (08185) onto
the turbo inlet tube and secure with the provided
hose clamp.
13. Install the provided heat shield mounting
bracket (070662) onto the heat shield as shown
using the provided hardware.
14. Cut the provided edge trim into three sections,
one section will be 26-1/2” long, one section will be
22” long and the shortest section will be 13” long.
15. Install the 26-1/2” long edge trim onto heat
shield #073193 as shown.
16. Install the heat shield onto the air lter housing
mounting locations and secure with the provided
hardware.
17. Install the provided vent tting into the K&N
®
intake tube as shown.
NOTE: Plastic NPT ttings are easy to cross
thread. Install the vent tting “hand” tight, then
turn it two complete turns with a wrench.
18. Install the provided BOV hose onto the BOV
valve but do not tighten the hose clamp at this time.
19. Install the K&N
®
intake tube into the coupler
at the turbo inlet tube and align with the mounting
bracket previously installed. Secure the tube with
the hardware and hose clamp provided.
20. Connect the BOV hose to the K&N
®
intake tube
and secure with the provided hose clamp.
21. Connect the crank case vent hose to the K&N
®
intake tube and secure with the factory hose clamp.