Owners manual
INSTALLATION INSTRUCTIONS
Continued
7. Lift up and remove the air box from the vehicle.
NOTE: K&N Engineering, Inc., recommends that
customers do not discard factory air intake.
8. Remove the air box mounting bracket from the
back of the headlight.
9. Disconnect the vent line from the engine sound
tube.
NOTE: Some vehicles may not be equipped
with a vent line attached to the sound tube.
10. Remove the two nuts securing the engine
sound drum to the intake manifold.
11. Loosen the hose clamp securing the engine
sound tube to the tting in the rewall.
12. Remove the engine sound drum assembly from
the vehicle.
13. Install the provided cap onto the tting in the
re wall for the sound drum.
14. Install the lter adapter and mounting bracket
(064304) onto the heat shield as shown using the
provided hardware.
15. Install the mounting bracket (064305) onto the
heat shield as shown using the provided hardware.
16.Install the provided edge trim onto the heat
shield as shown.
NOTE: Some trimming of the edge trim will be
necessary.
17. Install the K&N
®
air lter onto the lter adapter
and secure with the provided hose clamp.
18. Install the provided rubber mounted stud onto
the air box mounting location on the inner fender a
show.
19. Remove the bolt securing the coolant tube to
the engine.
20. Set the lter assembly into position and secure
to the rubber mount and coolant tube mounting
location with the provided hardware.
NOTE: Be sure to place the spacer between
bracket #064305 and the coolant tube bracket.
21. Remove the bolt securing the air sensor into
the factory air box and then remove the sensor.
22. Install the air sensor into the K&N
®
intake tube
and secure with the provided hardware.