Owners manual

INSTALLATION INSTRUCTIONS
Continued
10. Install the lter adapter into the heat shield and
secure with the provided hardware.
11. Install the provided edge trim onto the heat
shield as shown.
NOTE: Some trimming of the edge trim will be
necessary.
12. Install the provided inserted nut onto the heat
shield mounting bracket and secure with the
provided hardware.
NOTE: Do not completely tighten at this time.
13. Install the provided silicone hose (5-576) onto
the lter adapter as shown and secure with the
provided hose clamp.
15. Install the heat shield assembly into the vehicle
so the inserted nut goes into the air box mounting
grommet hole and the tab goes onto the air box
mounting stud. Secure the heat shield with the
provided hardware.
14. Install the provided rubber fender washer onto
the outer air box mounting stud.
16. Remove the two screws that secure the mass
air sensor into the factory intake tube and then
remove the mass air sensor from the factory upper
air box.
17. Install the mass air sensor into the K&N
®
intake tube as shown and secure with the provided
hardware.
18. Install the provided vent tting into the K&N
®
intake tube as shown.
NOTE: Plastic NPT ttings are easy to cross
thread. Install the vent tting “hand” tight, then
turn it two complete turns with a wrench.
19. Install the provided silicone hose (08629) onto
the K&N
®
intake tube as shown. Install the K&N
®
intake tube assembly onto the throttle body and
lter adapter, adjust the tube in the hoses for
proper tment. Once properly tted, secure the
tube with the provided hose clamps.
20. Remove the 90° vent hose from the crank case
vent tube. Then install the provided silicone vent
hose; trim the hose for proper t and install it onto
the tting installed into the K&N
®
intake tube.
21. Install the K&N
®
air lter and secure with the
provided hose clamp.
NOTE: Drycharger
®
air lter wrap; part #
RC-5107DK is available to purchase separately.
To learn more about Drycharger
®
lter wraps or
look up color availability please visit
http://www.knlters.com
®
.
22. Reconnect the mass air sensor electrical
connection.
23. Reinstall the engine cover.
NOTE: Some trimming may need to be
performed on the engine cover to prevent
contact with the intake tube.
9. Install the heat shield mounting bracket (083126)
onto the heat shield and secure with the provided
hardware.
7. Remove the lower air box mounting nuts and
then remove the lower air box assembly.
NOTE: K&N Engineering, Inc., recommends that
customers do not discard factory air intake.
8. Remove the air box mounting grommet shown
from the frame rail.