Owners manual

INSTALLATION INSTRUCTIONS
Continued
8. Remove the complete lower airbox assembly
from the vehicle as shown.
NOTE: K&N Engineering, Inc., recommends that
you do not discard your factory air intake.
9. Release the spring clamp that secures the
crankcase vent hose to the valve cover, then
disconnect the crankcase vent hose from the valve
cover.
10. Ensure that the engine is not hot, then release
the spring clamp that secures the coolant bypass
hose to the intake manifold port. Disconnect the
coolant bypass hose from the intake port.
NOTE: Ensure the engine is cool before
disconnecting the coolant bypass hose.
Capture any lost coolant.
11. Release the spring clamp that secures the
coolant bypass hose to the throttle body, then
disconnect the coolant bypass hose from the
throttle body. Remove the bypass/crank case vent
hose assembly from the vehicle.
NOTE: Ensure the engine is cool before
disconnecting the coolant bypass hose.
Capture any lost coolant.
12. Install the provided bypass hose onto the
throttle body and intake manifold ports. Secure with
the provided hose clamps.
13. Remove the two screws that secure the mass
air sensor to the upper airbox, then remove the
mass air sensor as shown.
14. Install the mass air sensor into the K&N
®
intake tube and secure with the provided hardware.
15. Install the four 6mm studs into the air lter
adapter; threading them down until they bottom into
the insert. tighten nger-tight.
16. Place one of the provided gaskets onto the air
lter adapter as shown.
17. Install the air lter adapter into the heat shield
as shown. Place the remaining gasket onto the
exposed studs as shown.
18. Install the K&N
®
intake tube onto the exposed
studs and secure with the provided hardware.
19. Install the provide edge trim onto the heat
shield as shown.
NOTE: Some trimming of the edge trim may be
necessary.
20. Install mounting bracket (#06507) onto the heat
shield using the provided hardware as shown.
7. Un-hook the fresh air supply duct from the
lower airbox as shown.
22. Install silicone hose (#08440) onto the throttle
body and secure with the provided hose clamp.
21. Install the K&N
®
air lter onto the air lter
adapter and secure with the provided hose clamp.