Owners manual

INSTALLATION INSTRUCTIONS
Continued
10. Install the saddle clamp onto the tube mount-
ing bracket as shown with the provided hardware.
11. Install the tube mounting bracket assembly
onto the rear threaded boss on the engine with the
provided hardware.
12. Remove the power steering reservoir mounting
bolt shown.
NOTE: This bolt will be reused.
13. Install the “L” bracket onto the power steer-
ing reservoir using the bolt removed in step #12.
NOTE: Do not completely tighten at this time.
14. Install the “L” bracket onto the heat shield us-
ing the supplied spacer between the heat shield
and bracket.
15. Install the provided edge trim onto the heat
shield as shown.
NOTE: Some trimming of the edge trim may be
necessary.
16. Install the heat shield assembly into the vehicle
and secure with the provided hardware.
17. Remove the two screws that secure the mass
air sensor to the airbox and then remove the mass
air sensor from the airbox.
18. Remove the clamp that secures the crankcase
vent and then remove the crankcase vent tting
from the airbox.
19. Remove the engine cover mounting stud from
the airbox as shown.
NOTE: This stud will be reused.
20. Install the supplied gasket onto the mass air
sensor as shown.
21. Install the mass air sensor assembly into the
K&N
®
intake tube using the supplied hardware.
22. Install the supplied grommet into the K&N
®
intake tube as shown.
23. Install the stock crankcase vent tting into the
grommet that was installed in the K&N
®
intake tube
in the previous step.
24. Install the supplied ¼”npt tting into the K&N
®
intake tube as shown.
NOTE: Plastic NPT ttings are easy to cross
thread. Install the vent tting “hand” tight, then
turn it two complete turns with a wrench.
25. Install the engine cover mounting stud into the
K&N
®
intake tube as shown, this stud was re-
moved in step #19.
26. Install the silicone hose (08434) onto the
throttle body and secure with the provided hose
clamp.
27. Install the K&N
®
intake tube into the silicone
hose at the throttle body and align with the saddle
clamp. Secure the intake tube with the provided
hose clamps.