Owners manual

INSTALLATION INSTRUCTIONS
Continued
9. Detach the coolant hose from the tting on
the intake manifold, and from the tting on the
underside of the throttle body.
10. Detach the air control valve vacuum hose and
the air control solenoid vacuum hose from the hard
lines.
11. On vehicles equipped with air injection pump,
detach the vacuum hose from the air control
solenoid valve vacuum control solenoid valve.
12. On vehicles equipped with air injection pump,
detach the vacuum hose from the air control
vacuum check valve.
13. Remove the pipe assembly.
14. On vehicles equipped with air injection pump,
attach the provided 4mm (long) vacuum hose to
the air control solenoid valve.
15. On vehicles equipped with air injection pump,
attach the provided 4mm(short) vacuum hose to
the check valve.
16. On vehicles equipped with air injection pump,
attach the air control solenoid valve vacuum hose
to the air control valve hard line. (lower hard line).
17. On vehicles equipped with air injection pump,
attach the check valve vacuum line to the check
valve hard line (upper hard line).
18. Attach the provided 1/4” reinforced hose to the
tting on the intake manifold and the tting on the
underside of the throttle body.
19. Using the provided hardware assemble the
saddle bracket and the “L” bracket assembly.
20. Using the provided hardware attach the long “L”
bracket to the heat shield.
21. Using the provided hardware attach the saddle
bracket assembly to the heat shield.
22. Install the edge trim to the heat shield
assembly.
23. Using the provided hardware, install the small
“L” bracket onto the vehicle as shown.
24. Using the provided hardware, install the heat
shield assembly and secure the brackets to the
original air box mounting locations.
25. Install the silicone hump hose with provided
hose clamps, onto the K&N
®
intake tube as shown.
17a. Remove the bolt shown that secures the
vacuum canister to the chassis.
17b. Using the provided hardware, install the
provided bracket (083155) along with the provided
spacer and the factory vacuum canister.
NOTE: The spacer should be placed between
the bracket and vacuum canister.
17c. Using the provided hardware, secure the
vacuum solenoid to the lower hole in the bracket.
Then secure the vacuum line to the upper hole with
the provided mounting head tie wrap. Using the two
remaining tie wraps, secure the vacuum lines to the
wiring harness.