Owners manual

INSTALLATION INSTRUCTIONS
Continued
10. Remove the air box mounting grommet shown
from the frame rail.
11. Install the heat shield mounting bracket
(083126) onto the heat shield as shown using the
provided hardware.
12. Install the lter adapter onto the heat shield and
secure with the provided hardware.
13. Install the edge trim onto the heat shield as
shown.
NOTE: Some trimming of the edge trim will be
necessary.
14. Install the inserted nut onto the heat shield
mounting bracket using the provided hardware. Do
not completely tighten at this time.
15. Install the heat shield assembly into the vehicle
so the inserted nut goes into the air box mounting
grommet hole and the tab goes onto the air box
mounting stud. Secure the heat shield with the
provided hardware.
16. Install the silicone hose (08761) onto the
throttle body and secure with the provided hose
clamp.
17. Install the silicone hose (08418) onto the lter
adapter and secure with the provided hose clamp.
18. Remove the two screws and then remove the
mass air sensor from the factory air box.
19. Install the provided gasket onto the mass air
sensor adapter as shown.
20. Install the mass air sensor into the adapter and
secure with the provided hardware.
21. Install the mass air sensor assembly into the
K&N
®
intake tube and secure with the provided
hardware.
NOTE: Be sure to place the mass air sensor
with the opening pointed towards the lter end
of the tube.
22. Install the provided 1/4 NPT tting into the
K&N
®
intake tube as shown.
NOTE: Plastic NPT ttings are easy to cross
thread. Install the vent tting “hand” tight, then
turn it two complete turns with a wrench.
23. Install the K&N
®
intake tube assembly into the
silicone hose at the lter adapter and then into the
silicone hose at the throttle body and secure with
the provided hose clamps.
7. Rotate the crank case vent tube 180°, then
release the retainer at the valve cover port and
then remove the crank case vent tube from the
valve cover port.
8. Remove the two air box retaining nuts shown.
9. Lift up and remove the air box from the vehicle.
NOTE: K&N Engineering, Inc., recommends that
customers do not discard factory air intake.