Owners manual

INSTALLATION INSTRUCTIONS
Continued
15. Install the two remaining rubber mounted studs
to the original air box mounting holes.
16. Install the heat shield onto the rubber mounted
studs as shown above.
17. Secure the upper bracket to the fan shroud with
the original bolt.
23. On 2000-02 models, install the three vents into
the intake tube in the orientation as shown above.
NOTE: Plastic NPT ttings are easy to cross
thread. Install the vent tting “hand” tight, then
turn it two complete turns with a wrench.
23a. Some 03 models, install the two vents and
plug into the intake tube in the orientation as shown
above.
24. Install the K&N
®
intake tube onto the
throttle body and secure with the provided hose
clamp.
25. Secure the saddle bracket to the tube with the
provided hose clamp.
29. Install the K&N
®
air lter onto the K&N
®
intake
tube as shown.
NOTE: Drycharger
®
air lter wrap; part #
RC-5100DK is available to purchase separately.
To learn more about Drycharger
®
lter wraps or
look up color availability please visit
http://www.knlters.com
®
.
14. Secure the two brackets to the heat shield
with the provided hardware, but do not tighten
completely.
18. Secure the lower bracket to the inner fender
well, using the original bolt.
19. Secure the heat shield tabs to the rubber
mounted studs with the provided hardware.
20. Install the silicon hose onto the throttle body
and secure it with the provided hose clamp.
21. Assemble the saddle bracket assembly as
shown above.
22. Install the saddle bracket assembly onto the
existing threaded boss on the cam cover, do not
tighten completely.
26. Re-connect the AC line to the K&N
®
intake tube
using the original bolt.
27. Install the three vent hoses onto the engine as
shown above. (see arrows)
NOTE: Some ‘03 models may come equipped
with only three vacuum lines.
28. Attach the three provided, and one existing
hose onto the K&N
®
intake tube as shown.
NOTE: Some ‘03 models may come equipped
with a total of three vacuum lines.
30. Tighten all brackets and bumper studs and
check for proper clearances.
13. Install the two rubber mounted studs to the
heat shield with the provided hardware, but do not
tighten completely.
12. Apply the edge trim to the K&N
®
heat shield as
shown above, trim if needed.
10. Apply the provided gasket to the mass-air
sensor with the sticky side down.
11. Install the mass-air sensor into the K&N
®
intake
tube and secure with the provided spacers and
screws as shown.