Owners manual

INSTALLATION INSTRUCTIONS
Continued
10. Install “L” bracket (#070066) onto the heat
shield as shown.
11. Install “L” bracket (07190) onto the heat shield
as shown.
12. Install the edge trim onto the heat shield as
shown. Trim as needed.
13. Using a screw driver, push the center of the
plastic inner fender retaining clip through, then
remove the clip from the inner fender.
14. Install the heat shield onto the vehicle and
secure with the provided hardware.
NOTE: On four wheel drive vehicles, insert
dierential vent retaining clip into the hole
provided on the heat shield.
15. Assemble the saddle bracket assembly with the
provided hardware as shown.
16. Locate the ground wire attached to the engine
cam cover and remove the bolt securing it using a
10mm wrench.
17. Install the saddle bracket assembly and
ground wire removed in step #16 with the provided
hardware as shown.
18. Install the provided silicone hose (08690) onto
the throttle body with the provided hose clamps as
shown.
19. Remove the two screws that secure the mass
air sensor to the air box lid, then remove the mass
air sensor as shown.
20. Apply the provided gasket to the mass air
sensor adapter as shown; sticky side down.
21. Insert the mass air sensor into the mass air
sensor adapter and secure with the provided
hardware.
22. Install the mass air sensor assembly into the
intake tube with the opening of the sensor pointing
towards the air lter end of the tube as shown.
23. Secure the mass air sensor assembly onto the
K&N
®
intake tube with the provided hardware.
24. Install the K&N
®
intake tube onto the throttle
body and align with the saddle bracket.
25. Secure the K&N
®
intake tube to the saddle
bracket with the provided hose clamp. Also tighten
the hose clamp at the throttle body.
26. Install the provided hose mender into the two
crank case vent hoses and secure the existing
spring clamps as shown.
27. Install the provided silicone hose onto the hose
mender, then install the hoses onto the intake tube
as shown.