Owners manual

INSTALLATION INSTRUCTIONS
Continued
12. Install the provided edge trim onto the heat
shield as shown.
NOTE: Some trimming of the edge trim may be
necessary.
13. Install the provided “L” bracket #070026 onto
the heat shield with the provided hardware as
shown.
14. Install the provided “L” bracket #010054 onto
the heat shield with the provided hardware as
shown.
15. Install the heat shield assembly into the vehicle
as shown. Secure the rear heat shield mounting
bracket to the fresh air duct with the bolt removed
in step #11. Secure the forward heat shield mount-
ing bracket to the inner fender with the provided
hardware as shown.
16. Install the heat shield mounting bracket
#070840 onto the heat shield so that the other end
of the bracket rests on the mounting tab on the
strut tower as shown.
17. Install the silicone hose #08421 onto the
throttle body with the provided hardware as shown.
18. Install the provided rubber mounted stud onto
the K&N
®
intake tube as shown.
19. Install the tube mount bracket # 070065 onto
the K&N
®
intake tube as shown.
20. Set the K&N
®
intake tube in place through the
heat shield but not onto the throttle body as shown.
21. Install the air lter onto the K&N
®
intake tube
and secure with the provided hose clamp.
22. Install the K&N
®
intake tube into the silicone
hose at the throttle body and align the mounting
bracket with the heat shield bracket and mounting
tab on the strut tower. Tighten the hose clamp and
secure the bracket to the heat shield bracket and
mounting tab on the strut tower with the provided
hardware.
23. Install the provided silicone vent hose onto the
K&N
®
intake tube and then install the crankcase
vent tube into the silicone hose as shown.
24. Reinstall the engine cover and secure in place
with the three 1/4 turn fasterners.
27. It will be necessary for all K&N
®
high ow intake
systems to be checked periodically for realignment,
clearance and tightening of all connections. Failure
to follow the above instructions or proper mainte-
nance may void warranty.
26. The C.A.R.B. exemption sticker, (attached),
must be visible under the hood so that an emis-
sions inspector can see it when the vehicle is
required to be tested for emissions. California
requires testing every two years, other states may
vary.
25. Reconnect the vehicle’s negative battery cable.
Double check to make sure everything is tight and
properly positioned before starting the vehicle.
1. Start the engine with the transmission in neutral
or park, and the parking brake engaged. Listen for
air leaks or odd noises. For air leaks secure hoses
and connections. For odd noises, find cause and
repair before proceeding. This kit will function iden-
tically to the factory system except for being louder
and much more responsive.
2. Test drive the vehicle. Listen for odd noises or
rattles and x as necessary.
3. If road test is ne, you can now enjoy the added
power and performance from your kit.
4. K&N Engineering, Inc., suggests checking the air
lter element periodically for excessive dirt build-
up. When the element becomes covered in dirt (or
once a year), service it according to the instructions
on the Recharger
®
service kit, part number 99-5050
or 99-5000.
ROAD TESTING:
* FREE K&N
®
decal To register your warranty, please see us online at knlters.com/register. FREE K&N
®
decal *
• 1455 CITRUS ST., P.O. BOX 1329, RIVERSIDE, CA., U.S.A. 92502 • TECH SERVICE 800-858-3333 • FAX [phone]
• e-mail: tech@knlters.com
®
• WWW: http://www.knlters.com
®
19524B
5/05/14