Owners manual

INSTALLATION INSTRUCTIONS
Continued
8. Install the provided gasket onto the mass air
sensor adapter as shown.
9. Remove the two screws that secure the mass air
sensor onto the stock intake tube and then remove
the mass air sensor as shown.
10. Install the mass air sensor into the adapter and
secure with the provided hardware.
11. Install the mass air sensor assembly into the
K&N
®
Intake Tube.
NOTE: Be sure the opening of the mass air
sensor is pointed towards the lter end of the
tube.
12. Secure the mass air sensor assembly to the
K&N
®
Intake Tube with the provided hardware.
13. Remove the lter minder and grommet from the
stock intake tube as shown.
14. Install the lter minder and grommet into the
K&N
®
Intake Tube as shown.
15. Install the “L” bracket (07805) onto the heat
shield as shown with the provided hardware.
16. Install the “L” bracket (070952) onto the heat
shield as shown using the
provided hardware.
17. Install one of the 11” edge trims onto the heat
shield as shown.
NOTE: Some trimming of the edge trim may be
necessary.
18. Install the remaining 11” edge trim onto the heat
shield as shown.
NOTE: Some trimming of the edge trim may be
necessary.
19. Install the Heat shield assembly onto the factory
air box mounting plate and
secure with the factory bolts removed in step #7.
20. Set the K&N
®
Air Filter into the heat shield as
shown.
21. Install the K&N
®
Intake Tube into the silicone
hose at the turbo inlet and into the heat shield, then
secure the K&N
®
Intake Tube with the provided hose
clamp and hardware as shown.
22. Install the K&N
®
Air Filter onto the intake tube
and secure with the provided hose clamp.
23. Install the 20” piece of edge trim onto the lter
cover as shown.
NOTE: Some trimming of the edge trim may be
necessary.