Owners manual

INSTALLATION INSTRUCTIONS
Continued
11. Install the provided rubber mounted studs onto
the heat shield mounting tray using the provided
hardware.
NOTE: The fender washers should be placed on
either side of the mounting tray with the rubber
washer in between each fender washer.
12. Remove the battery tray mounting bolt shown.
NOTE: This bolt will be reused.
13. Install the heat shield assembly into position
so that the rubber mounted studs protrude through
bottom of the heat shield. Secure the heat shield
with the provided hardware and the factory battery
tray bolt removed in step #12.
14. Remove the lter minder and grommet from the
factory air lter housing as shown.
15. Install the lter minder and grommet into the
K&N
®
intake tube as shown.
16. Install the supplied crank case grommet into
the K&N
®
intake tube as shown.
17.Remove the mass air sensor from the factory air
lter housing.
18. Install the provided gasket onto the K&N
®
mass
air sensor adapter.
19. Install the mass air sensor into the K&N
®
mass
air sensor adapter and secure with the provided
hardware.
20. Install the mass air sensor assembly onto the
K&N
®
intake tube as shown and secure with the
provided hardware as shown.
NOTE: Be sure the mass air sensor is
positioned with the connector face down as in
the photo.
21. Install the provided silicone (087121) hose
onto the K&N
®
intake tube with the hose clamps
provided as shown.
NOTE: Do not tighten the hose clamp at this
time.
22. Install the K&N
®
intake tube assembly into the
heat shield and slide the silicone hose onto the
turbo inlet. Secure the intake tube to the mounting
bracket on the heat shield with the provided
hardware and then position the silicone hose onto
the turbo and secure with the hose clamps.
23. Insert the crank case vent tting into the
grommet in the K&N
®
intake tube.
NOTE: Using some spray lube on the grommet
and tting will ease the installation. On vehicles
using the supplied 90º vent tting, attach the
crank case vent hose to the 90º tting and
secure with the provided hose clamp.
24. Attach the lter minder extension harness
provided into the factory harness and then connect
the open end to the lter minder.
25. Install the K&N
®
Air Filter onto the K&N
®
intake
tube and secure with the hose clamp.
16a. On models that have the crank case vent
tting attached to the stock intake tube, install
the supplied 90º vent tting into the grommet as
shown.
8. Install the provided edge trim onto the heat
shield as shown.
NOTE: Some trimming of the edge trim will be
necessary.
9. Install the tube mounting bracket (06712) onto
the heat shield using the provided hardware and
spacers.
NOTE: The spacers should be placed between
the bracket and heat shield.
10. Remove the three air box mounting grommets
shown from the mounting tray.